Crowborough · East Sussex
Bespoke Mirrors in Crowborough
Mirrors with black edges in Crowborough cannot be restored, but we can measure and replace them with new mirror bonded using a compatible adhesive to protect the silver.
- TN6
- Guide from £205
Gym wall mirrors in Crowborough
A safety-backed mirror has a film bonded across its back that holds the pieces together if the glass breaks, so fragments stay on the backing instead of falling or scattering. Some backing films are classified for impact under BS EN 12600, and the film is applied before fitting.
Safety backing is a sensible choice wherever someone could fall or knock against a mirror, such as sliding wardrobe doors, full-height mirrors, children's rooms, gyms and dance studios. We recommend it at survey wherever the position or use of the room suggests it.
Large mirrors are usually fixed with mirror adhesive and supported at the base by a slim channel or clips while the adhesive cures and afterwards. Smaller mirrors can be screw-fixed through drilled holes with decorative caps, which also lets them be removed later.
Mirrors must be bonded with an adhesive made to be compatible with mirror backing. Some general-purpose adhesives and acidic sealants can attack the protective coatings and the silver, causing dark patches that spread from behind. We only use mirror-compatible products.
What's included
- Final clean and advice on protecting the edges
- Fixing with mirror-compatible adhesive, clips or channels
- Survey, measuring or templating of the wall or recess
- Cut-outs and drilled holes for sockets, switches or fixings
Crowborough at a glance
- Postcodes covered
- TN6 and the surrounding area, including Tunbridge Wells, East Grinstead and Tonbridge
- Coast
- Crowborough is well inland, around 30 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Crowborough the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 62° and 16.3 hours in midsummer. A mirror opposite or beside a window reflects daylight deeper into a room, which helps dark north-facing spaces through winter. Low direct sun on a large mirror can cause glare, so its position and any tint are worth considering.
- Access and setting
- Older rural homes often have uneven walls of stone or lime plaster, which can distort a bonded mirror unless the wall is levelled or a backing board is used. Damp solid walls also need checking before a mirror is fixed to them.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Crowborough
| Typical job | Guide price inc VAT |
|---|---|
| Polished mirror, 1200 × 900 mm | £205 – £265 |
| Safety-backed mirror, 1800 × 1000 mm | £365 – £465 |
| Gym mirror wall, 4000 × 2000 mm | £995 – £1,295 |
Specification choices
Bevelled edge
An angled border ground and polished around the edge that catches the light and frames the mirror without needing a separate frame.
Tinted mirror
Grey or bronze tinted mirror that softens the reflection and adds warmth or depth, often used as a feature wall or in hospitality spaces.
Clear silver mirror
Standard silver-coated float glass mirror, cut to size, suited to most rooms, wardrobes and wall mirrors where a true, neutral reflection is wanted.
Bespoke Mirrors in Crowborough: questions
What edge finishes can I choose for a bespoke mirror?
The main choices are a flat polished edge, a bevelled edge and an arrised edge. Polished edges give a clean, frameless look and suit mirror walls, bevels add an angled border that catches the light, and arrised edges simply take off the sharpness where a frame or channel will hide them. Bevel width can usually be chosen too.
Can a large mirror be fixed to plasterboard?
Often, yes, but it depends on the board, its fixings and the surface finish. Adhesive grips the paint or plaster layer, so flaky paint or weak skim can let go under the weight. We check the wall at survey and may add a base channel, mechanical fixings into studs, or a backing board to spread the load.
How is a large mirror fixed to the wall?
Large mirrors are usually bonded with an adhesive made for mirror backing and supported along the bottom edge by a slim channel or clips. The support carries the weight while the adhesive cures and adds security afterwards. Smaller mirrors can be screw-fixed through drilled holes with decorative caps, which makes them easier to remove later.
Can I have a bespoke mirror in a bathroom?
Yes, provided the room is well ventilated and the mirror is protected from standing water. We use mirror that meets the relevant standard for internal use, bond it with a compatible adhesive and keep edges away from splashes where possible. A heated demister pad can keep part of the mirror clear, wired in by a qualified electrician.
Do you cover Crowborough for bespoke mirrors?
Yes. We can quote for bespoke mirrors across Crowborough and the surrounding East Sussex area, including postcode districts TN6, and nearby Tunbridge Wells, East Grinstead and Tonbridge. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Crowborough
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.