Walkden · Greater Manchester
Bespoke Mirrors in Walkden
An awkward alcove or sloping ceiling in Walkden does not have to rule out a mirror, because each one we fit is templated and cut to the real shape of the space.
- M28
- M38
- Guide from £205
About bespoke mirrors in Walkden
Mirrors must be bonded with an adhesive made to be compatible with mirror backing. Some general-purpose adhesives and acidic sealants can attack the protective coatings and the silver, causing dark patches that spread from behind. We only use mirror-compatible products.
Edge finish affects both look and safety. Flat polished edges suit frameless mirrors and mirror walls, bevelled edges add an angled border that catches the light, and a simple arrised edge takes the sharpness off edges that will be hidden by a frame or channel.
Black edges, often called edge creep, are corrosion of the silver layer, usually started by moisture or cleaning fluid getting into the edges, or by an unsuitable adhesive. Once the silver has corroded it cannot be restored, so the mirror has to be replaced.
In bathrooms, good ventilation does more to protect a mirror than anything else, because steam and condensation reach the edges and backing. A heated demister pad behind the mirror keeps it clear after showers, but it needs wiring by a qualified electrician.
What you get
- Cut-outs and drilled holes for sockets, switches or fixings
- Final clean and advice on protecting the edges
- Safety backing film where the position calls for it
- Mirror cut to size with your chosen edge finish
Local details for Walkden
- Postcodes covered
- M28, M38 and the surrounding area, including Farnworth, Swinton and Tyldesley
- Coast
- Walkden is well inland, around 30 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Walkden the midwinter sun reaches about 13° above the horizon at noon, with roughly 7.2 hours of daylight, rising to about 60° and 16.8 hours in midsummer. A mirror opposite or beside a window reflects daylight deeper into a room, which helps dark north-facing spaces through winter. Low direct sun on a large mirror can cause glare, so its position and any tint are worth considering.
- Access and setting
- Older rural homes often have uneven walls of stone or lime plaster, which can distort a bonded mirror unless the wall is levelled or a backing board is used. Damp solid walls also need checking before a mirror is fixed to them.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Walkden
| Typical job | Guide price inc VAT |
|---|---|
| Polished mirror, 1200 × 900 mm | £205 – £265 |
| Safety-backed mirror, 1800 × 1000 mm | £365 – £465 |
| Gym mirror wall, 4000 × 2000 mm | £995 – £1,295 |
Choosing your bespoke mirrors
Bevelled edge
An angled border ground and polished around the edge that catches the light and frames the mirror without needing a separate frame.
Clear silver mirror
Standard silver-coated float glass mirror, cut to size, suited to most rooms, wardrobes and wall mirrors where a true, neutral reflection is wanted.
Heated demister pad
A thin heating pad bonded behind a bathroom mirror to keep an area clear of steam, wired in by a qualified electrician.
Bespoke Mirrors in Walkden: questions
How is a large mirror fixed to the wall?
Large mirrors are usually bonded with an adhesive made for mirror backing and supported along the bottom edge by a slim channel or clips. The support carries the weight while the adhesive cures and adds security afterwards. Smaller mirrors can be screw-fixed through drilled holes with decorative caps, which makes them easier to remove later.
What edge finishes can I choose for a bespoke mirror?
The main choices are a flat polished edge, a bevelled edge and an arrised edge. Polished edges give a clean, frameless look and suit mirror walls, bevels add an angled border that catches the light, and arrised edges simply take off the sharpness where a frame or channel will hide them. Bevel width can usually be chosen too.
What is a safety-backed mirror and do I need one?
A safety-backed mirror has a film bonded across its back that holds the pieces together if the glass breaks. You should consider one wherever someone could knock or fall against the mirror, such as wardrobe doors, full-height mirrors, gyms, dance studios and children's rooms. We recommend it at survey when the position or use of the room calls for it.
What affects the cost of a bespoke mirror?
The main cost drivers are the size and thickness of the mirror, the number of panels, the edge finish, any tint or low-iron glass, safety backing, cut-outs and the fixing method. Very large single sheets, access through narrow stairs and full mirror walls also affect the price. See the guide prices for typical ranges.
Do you cover Walkden for bespoke mirrors?
Yes. We can quote for bespoke mirrors across Walkden and the surrounding Greater Manchester area, including postcode districts M28 and M38, and nearby Farnworth, Swinton and Tyldesley. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Walkden
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.