Montrose · Angus & Dundee
Curtain Walling in Montrose
Curtain walling in Montrose starts with a survey of the openings, structure and access, then a written quote that fixes the price for the system and glass shown.
- DD10
- Guide from £455 per m²
Glazed facade systems across Montrose
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
The Centre for Window and Cladding Technology publishes the Standard for systemised building envelopes, the recognised UK industry standard for specifying, testing and assessing curtain walling. It draws in BS EN 13830 and the relevant building regulations, and is often referenced in commercial specifications.
Where a glazed screen must resist fire, the glass only performs as part of a fire-resistant system tested with its frame, seals, beads and fixings. Ratings use letters such as E for integrity and EI for integrity and insulation, and components must not be swapped without test evidence.
Toughened glass can very occasionally break on its own because of nickel sulphide inclusions. Heat soak testing to BS EN 14179 reduces that risk by breaking flawed panes in the factory, and it is often specified for toughened glass high on facades where a breakage is harder to deal with.
What's included
- Survey of openings, supporting structure and access
- Final inspection, clean and maintenance guidance
- Sealing, weathering and drainage details at all interfaces
- System selection and glass specification for the building
About Montrose for this job
- Postcodes covered
- DD10 and the surrounding area, including Arbroath, Forfar and Carnoustie
- Coast
- Montrose is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Facades near the sea face salt-laden wind and driving rain, which attack frame finishes and stress seals. Suitable coating specifications, regular washing, gasket checks and higher design wind loads for exposed sites all matter for curtain walling there.
- Daylight and sun
- In Montrose the midwinter sun reaches about 10° above the horizon at noon, with roughly 6.5 hours of daylight, rising to about 57° and 17.5 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in Scotland
- Section 4 (Safety) of the Scottish Technical Handbooks covers glazing that people could collide with, such as glass in and beside doors and low-level glazing, where safety glass is needed.
Guide prices in Montrose
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Glass in a fire-resisting door or screen must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
Choosing your curtain walling
Stick curtain wall
Mullions and transoms assembled on site with glass and panels fitted afterwards, suited to low-rise buildings, entrances and ground-floor screens.
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Curtain Walling in Montrose: questions
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
Does new curtain walling need building regulations approval?
New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.
What affects the cost of curtain walling?
The main cost drivers are facade area, system type, glass specification, infill panels, opening vents, building height and access equipment such as scaffolding, hoists or cranes. Structural silicone glazing, unitised panels, fire-resisting sections and testing requirements add cost. See the guide prices for typical ranges, and your written quote fixes the price for the specification.
Do you cover Montrose for curtain walling?
Yes. We can quote for curtain walling across Montrose and the surrounding Angus & Dundee area, including postcode districts DD10, and nearby Arbroath, Forfar and Carnoustie. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Montrose
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.