Call 0800 088 6248

Buckinghamshire · England

Curtain Walling in Buckinghamshire

Our glaziers install aluminium curtain walling and full-height glazed screens in Buckinghamshire, coordinating with other trades and sealing every interface with the structure.

  • Guide from £455 per m²
  • 8 towns covered
  • Postcode areas HP, MK, SL, UB

Get your free quote

Start with your postcode. A glazier will be in touch to arrange a free survey.

By sending this form you agree we can contact you about this enquiry. See our privacy policy for how we use your details.

No obligation. Prefer to talk? Call 0800 088 6248 or WhatsApp us.

About curtain walling in Buckinghamshire

The price depends on the facade area, the system type, glass specification such as solar control or triple glazing, infill panels, opening vents, building height and access equipment, and design and testing requirements. Replacement units also depend on how the glass is retained. See the guide prices for typical ranges.

Building regulations require external walls to limit the spread of fire, so curtain walling design has to consider how its materials react to fire and how fire could pass between floors. The requirements depend on the building's height and use, and differ between the UK nations.

A stick system is built on site piece by piece. Aluminium mullions and transoms are fixed to the structure first, then the glass and infill panels go in, and finally the pressure plates and caps. It suits low-rise buildings and screens but needs access to both faces.

Curtain walling needs planned upkeep. Clean frames and glass regularly, keep drainage outlets clear, and inspect gaskets, seals and fixings for shrinkage, gaps or corrosion. Failed or misted sealed units can usually be replaced individually without removing the surrounding framing.

Glass curtain wall on an office building against a blue sky

Towns we cover for curtain walling in Buckinghamshire

Choose your town for local details, nearby areas and the postcode districts we cover.

What applies in Buckinghamshire

Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.

If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.

Buckinghamshire is inland, around 66 km from the nearest coast at its closest point, so salt exposure is rarely a factor.

City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.

Guide prices

Guide prices inc VAT for typical jobs. Remote and island locations are quoted by arrangement. Your written quote fixes the price after measuring.
Typical jobGuide price inc VAT
Curtain walling, per m² (stick system)£455 – £795
Curtain walling, per m² (unitised)£545 – £955

Choosing your curtain walling

Capped system

Glass clamped by pressure plates behind a visible external cap, available in different profiles and colours to emphasise the grid.

Solar control glass

Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.

Unitised curtain wall

Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.

Opaque spandrel panels

Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.

Curtain Walling in Buckinghamshire: questions

What glass is used in curtain walling?

Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.

Does new curtain walling need building regulations approval?

New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.

Should I choose a stick or unitised curtain wall?

A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.

How does curtain walling keep water out?

Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.

Which parts of Buckinghamshire do you cover for curtain walling?

We cover the whole of Buckinghamshire, including Milton Keynes, High Wycombe, Aylesbury, Bletchley and Amersham, and postcode areas HP, MK, SL, UB. Building rules for curtain walling here follow the regulations for England. Enter your postcode on the quote form and we will confirm cover; then a glazier will arrange a free survey before giving you a written quote.

Get a written quote in Buckinghamshire

Free survey for new glazing, clear guide prices and one point of contact for every glazing job.

CallGet a quote