Colwyn Bay · Clwyd
Curtain Walling in Colwyn Bay
Our glaziers install aluminium curtain walling and full-height glazed screens in Colwyn Bay, coordinating with other trades and sealing every interface with the structure.
- LL29
- LL28
- LL31
- Guide from £455 per m²
Aluminium curtain wall in Colwyn Bay
Curtain walling needs planned upkeep. Clean frames and glass regularly, keep drainage outlets clear, and inspect gaskets, seals and fixings for shrinkage, gaps or corrosion. Failed or misted sealed units can usually be replaced individually without removing the surrounding framing.
The Centre for Window and Cladding Technology publishes the Standard for systemised building envelopes, the recognised UK industry standard for specifying, testing and assessing curtain walling. It draws in BS EN 13830 and the relevant building regulations, and is often referenced in commercial specifications.
A stick system is built on site piece by piece. Aluminium mullions and transoms are fixed to the structure first, then the glass and infill panels go in, and finally the pressure plates and caps. It suits low-rise buildings and screens but needs access to both faces.
Where a glazed screen must resist fire, the glass only performs as part of a fire-resistant system tested with its frame, seals, beads and fixings. Ratings use letters such as E for integrity and EI for integrity and insulation, and components must not be swapped without test evidence.
Included as standard
- Supply and installation of framing, glass and panels
- Survey of openings, supporting structure and access
- System selection and glass specification for the building
- Fabrication drawings and coordination with other trades
Colwyn Bay at a glance
- Postcodes covered
- LL29, LL28, LL31 and the surrounding area, including Deganwy, Llandudno and Abergele
- Coast
- Colwyn Bay is about 2 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Facades near the sea face salt-laden wind and driving rain, which attack frame finishes and stress seals. Suitable coating specifications, regular washing, gasket checks and higher design wind loads for exposed sites all matter for curtain walling there.
- Daylight and sun
- In Colwyn Bay the midwinter sun reaches about 13° above the horizon at noon, with roughly 7.3 hours of daylight, rising to about 60° and 16.7 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in Wales
- In Wales, Approved Document N covers safety glazing: safety glass is needed in and around doors and in low-level glazing where people could walk into it.
Guide prices in Colwyn Bay
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Glass in a fire-resisting door or screen must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
What you can choose
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Integrated opening vents
Top-hung or parallel-opening vents built into the curtain wall grid to provide natural ventilation without breaking the facade line.
Curtain Walling in Colwyn Bay: questions
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
Does new curtain walling need building regulations approval?
New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
What affects the cost of curtain walling?
The main cost drivers are facade area, system type, glass specification, infill panels, opening vents, building height and access equipment such as scaffolding, hoists or cranes. Structural silicone glazing, unitised panels, fire-resisting sections and testing requirements add cost. See the guide prices for typical ranges, and your written quote fixes the price for the specification.
Do you cover Colwyn Bay for curtain walling?
Yes. We can quote for curtain walling across Colwyn Bay and the surrounding Clwyd area, including postcode districts LL29, LL28 and LL31, and nearby Deganwy, Llandudno and Abergele. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Colwyn Bay
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.