Larne · County Antrim
Curtain Walling in Larne
Planning a glazed facade in Larne? Our glaziers can survey the building and quote for stick or unitised curtain walling specified for its height, exposure and energy needs.
- BT40
- Guide from £455 per m²
About curtain walling in Larne
Curtain walling needs planned upkeep. Clean frames and glass regularly, keep drainage outlets clear, and inspect gaskets, seals and fixings for shrinkage, gaps or corrosion. Failed or misted sealed units can usually be replaced individually without removing the surrounding framing.
The look of the facade depends on how the glass is held. Capped systems clamp the glass with pressure plates hidden behind a visible cover cap, while structural silicone glazing bonds the glass to carrier frames so the outside reads as a smooth, almost frameless surface.
The Centre for Window and Cladding Technology publishes the Standard for systemised building envelopes, the recognised UK industry standard for specifying, testing and assessing curtain walling. It draws in BS EN 13830 and the relevant building regulations, and is often referenced in commercial specifications.
The price depends on the facade area, the system type, glass specification such as solar control or triple glazing, infill panels, opening vents, building height and access equipment, and design and testing requirements. Replacement units also depend on how the glass is retained. See the guide prices for typical ranges.
Included as standard
- Sealing, weathering and drainage details at all interfaces
- Fabrication drawings and coordination with other trades
- Supply and installation of framing, glass and panels
- Final inspection, clean and maintenance guidance
Working in Larne
- Postcodes covered
- BT40 and the surrounding area, including Carrickfergus, Ballyclare and Newtownabbey
- Coast
- Larne is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Facades near the sea face salt-laden wind and driving rain, which attack frame finishes and stress seals. Suitable coating specifications, regular washing, gasket checks and higher design wind loads for exposed sites all matter for curtain walling there.
- Daylight and sun
- In Larne the midwinter sun reaches about 12° above the horizon at noon, with roughly 6.9 hours of daylight, rising to about 59° and 17.1 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in Northern Ireland
- Technical Booklet V covers safety glazing in Northern Ireland, including glass in and around doors and low-level glazing where people could walk into it.
Guide prices in Larne
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Technical Booklet F1 sets the energy performance that replacement windows, doors and rooflights need to meet in Northern Ireland.
Choosing your curtain walling
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Stick curtain wall
Mullions and transoms assembled on site with glass and panels fitted afterwards, suited to low-rise buildings, entrances and ground-floor screens.
Curtain Walling in Larne: questions
Can a single broken glass unit in a curtain wall be replaced?
Usually, yes. In capped systems the cap and pressure plate are removed to release the glass, and a new unit is fitted and resealed. Structurally bonded glass needs the new unit bonding to its carrier, which takes more preparation. Height and access drive much of the work, so we survey the unit and access before quoting.
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
Does new curtain walling need building regulations approval?
New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.
Do you cover Larne for curtain walling?
Yes. We can quote for curtain walling across Larne and the surrounding County Antrim area, including postcode districts BT40, and nearby Carrickfergus, Ballyclare and Newtownabbey. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Larne
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.