Darlington · County Durham
Curtain Walling in Darlington
Curtain walling in Darlington starts with a survey of the openings, structure and access, then a written quote that fixes the price for the system and glass shown.
- DL1
- DL3
- DL2
- Guide from £455 per m²
About glazed facade systems in Darlington
BS EN 13830 is the product standard for curtain walling. It treats the system as a kit, including its fixings, set from vertical up to 15 degrees off vertical. Sloping roof glazing and patent glazing fall outside it and are covered by other standards.
The price depends on the facade area, the system type, glass specification such as solar control or triple glazing, infill panels, opening vents, building height and access equipment, and design and testing requirements. Replacement units also depend on how the glass is retained. See the guide prices for typical ranges.
Toughened glass can very occasionally break on its own because of nickel sulphide inclusions. Heat soak testing to BS EN 14179 reduces that risk by breaking flawed panes in the factory, and it is often specified for toughened glass high on facades where a breakage is harder to deal with.
Wind load on a facade rises with height, exposure and building shape, and it decides the mullion size, bracket design and glass thickness. Calculations for the specific site are part of the design, so a system suited to a sheltered ground-floor screen may not suit an exposed upper storey.
Included as standard
- Final inspection, clean and maintenance guidance
- System selection and glass specification for the building
- Survey of openings, supporting structure and access
- Supply and installation of framing, glass and panels
Darlington at a glance
- Postcodes covered
- DL1, DL3, DL2 and the surrounding area, including Newton Aycliffe, Stockton-on-Tees and Thornaby-on-Tees
- Coast
- Darlington is well inland, around 26 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Darlington the midwinter sun reaches about 12° above the horizon at noon, with roughly 7.0 hours of daylight, rising to about 59° and 17.0 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Darlington
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
Choosing your curtain walling
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Opaque spandrel panels
Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.
Curtain Walling in Darlington: questions
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
What is the difference between curtain walling and windows?
Curtain walling is a continuous framed wall of glass and panels that spans across floors and hangs off the building structure, carrying its own weight and wind loads. Windows sit within individual openings in a masonry or framed wall. Curtain walling suits large glazed areas and multi-storey facades, while windows suit punched openings.
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
Do you cover Darlington for curtain walling?
Yes. We can quote for curtain walling across Darlington and the surrounding County Durham area, including postcode districts DL1, DL3 and DL2, and nearby Newton Aycliffe, Stockton-on-Tees and Thornaby-on-Tees. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Darlington
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.