Billericay · Essex
Curtain Walling in Billericay
From capped systems to structural silicone glazing, we can quote for curtain walling in Billericay that balances daylight, solar gain and thermal performance.
- CM12
- Guide from £455 per m²
Billericay: curtain walling
BS EN 13830 is the product standard for curtain walling. It treats the system as a kit, including its fixings, set from vertical up to 15 degrees off vertical. Sloping roof glazing and patent glazing fall outside it and are covered by other standards.
Wind load on a facade rises with height, exposure and building shape, and it decides the mullion size, bracket design and glass thickness. Calculations for the specific site are part of the design, so a system suited to a sheltered ground-floor screen may not suit an exposed upper storey.
Building regulations require external walls to limit the spread of fire, so curtain walling design has to consider how its materials react to fire and how fire could pass between floors. The requirements depend on the building's height and use, and differ between the UK nations.
A stick system is built on site piece by piece. Aluminium mullions and transoms are fixed to the structure first, then the glass and infill panels go in, and finally the pressure plates and caps. It suits low-rise buildings and screens but needs access to both faces.
Included as standard
- Survey of openings, supporting structure and access
- Final inspection, clean and maintenance guidance
- Fabrication drawings and coordination with other trades
- Sealing, weathering and drainage details at all interfaces
About Billericay for this job
- Postcodes covered
- CM12 and the surrounding area, including Basildon, Wickford and Brentwood
- Coast
- Billericay sits roughly 14 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Facades near the sea face salt-laden wind and driving rain, which attack frame finishes and stress seals. Suitable coating specifications, regular washing, gasket checks and higher design wind loads for exposed sites all matter for curtain walling there.
- Daylight and sun
- In Billericay the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Billericay
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
Specification choices
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Integrated opening vents
Top-hung or parallel-opening vents built into the curtain wall grid to provide natural ventilation without breaking the facade line.
Capped system
Glass clamped by pressure plates behind a visible external cap, available in different profiles and colours to emphasise the grid.
Curtain Walling in Billericay: questions
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
Do glazed screens in offices and entrances need markings?
Large areas of clear glass that people could walk into need to be made visible. In England, the guidance for buildings other than dwellings puts manifestation at 850–1000mm and 1400–1600mm above the floor, and workplace rules across Great Britain require glass to be marked where needed for safety. Frosted bands or logos can meet this.
How long does a curtain walling project take?
Timescales depend on size and complexity. Design, approvals and fabrication of framing and glass usually take several weeks to a few months before installation starts. Installation then depends on the facade area, access and sequencing with other trades. Replacing individual units is much quicker once the glass is made. Your written quote sets out the expected programme.
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
Do you cover Billericay for curtain walling?
Yes. We can quote for curtain walling across Billericay and the surrounding Essex area, including postcode districts CM12, and nearby Basildon, Wickford and Brentwood. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Billericay
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.