Brixton · Greater London
Curtain Walling in Brixton
From capped systems to structural silicone glazing, we can quote for curtain walling in Brixton that balances daylight, solar gain and thermal performance.
- SW9
- SW2
- SW4
- Guide from £455 per m²
Aluminium curtain wall across Brixton
Curtain walling needs planned upkeep. Clean frames and glass regularly, keep drainage outlets clear, and inspect gaskets, seals and fixings for shrinkage, gaps or corrosion. Failed or misted sealed units can usually be replaced individually without removing the surrounding framing.
BS EN 13830 is the product standard for curtain walling. It treats the system as a kit, including its fixings, set from vertical up to 15 degrees off vertical. Sloping roof glazing and patent glazing fall outside it and are covered by other standards.
The price depends on the facade area, the system type, glass specification such as solar control or triple glazing, infill panels, opening vents, building height and access equipment, and design and testing requirements. Replacement units also depend on how the glass is retained. See the guide prices for typical ranges.
A stick system is built on site piece by piece. Aluminium mullions and transoms are fixed to the structure first, then the glass and infill panels go in, and finally the pressure plates and caps. It suits low-rise buildings and screens but needs access to both faces.
Included as standard
- Supply and installation of framing, glass and panels
- Sealing, weathering and drainage details at all interfaces
- System selection and glass specification for the building
- Survey of openings, supporting structure and access
About Brixton for this job
- Postcodes covered
- SW9, SW2, SW4 and the surrounding area, including Clapham, Peckham and Streatham
- Coast
- Brixton is well inland, around 33 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Brixton the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Brixton
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Opaque spandrel panels
Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.
Stick curtain wall
Mullions and transoms assembled on site with glass and panels fitted afterwards, suited to low-rise buildings, entrances and ground-floor screens.
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Curtain Walling in Brixton: questions
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
Can a single broken glass unit in a curtain wall be replaced?
Usually, yes. In capped systems the cap and pressure plate are removed to release the glass, and a new unit is fitted and resealed. Structurally bonded glass needs the new unit bonding to its carrier, which takes more preparation. Height and access drive much of the work, so we survey the unit and access before quoting.
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
How long does a curtain walling project take?
Timescales depend on size and complexity. Design, approvals and fabrication of framing and glass usually take several weeks to a few months before installation starts. Installation then depends on the facade area, access and sequencing with other trades. Replacing individual units is much quicker once the glass is made. Your written quote sets out the expected programme.
Do you cover Brixton for curtain walling?
Yes. We can quote for curtain walling across Brixton and the surrounding Greater London area, including postcode districts SW9, SW2 and SW4, and nearby Clapham, Peckham and Streatham. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Brixton
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.