Bromley · Greater London
Curtain Walling in Bromley
We cover Bromley and Greater London for curtain walling and glazed screens, from new commercial facades to replacing failed glass units in existing buildings.
- BR1
- BR2
- BR3
- BR4
- BR5
- BR6
- Guide from £455 per m²
Glazed facade systems in Bromley
The look of the facade depends on how the glass is held. Capped systems clamp the glass with pressure plates hidden behind a visible cover cap, while structural silicone glazing bonds the glass to carrier frames so the outside reads as a smooth, almost frameless surface.
The price depends on the facade area, the system type, glass specification such as solar control or triple glazing, infill panels, opening vents, building height and access equipment, and design and testing requirements. Replacement units also depend on how the glass is retained. See the guide prices for typical ranges.
Under the energy rules for new work in England, curtain walling performance is assessed for the whole system, including frames and opaque infill panels, not just the glass. Solar gain through the glass is also considered, so the glass choice balances heat loss, overheating and daylight.
BS EN 13830 is the product standard for curtain walling. It treats the system as a kit, including its fixings, set from vertical up to 15 degrees off vertical. Sloping roof glazing and patent glazing fall outside it and are covered by other standards.
What a typical job includes
- System selection and glass specification for the building
- Supply and installation of framing, glass and panels
- Final inspection, clean and maintenance guidance
- Fabrication drawings and coordination with other trades
Working in Bromley
- Postcodes covered
- BR1, BR2, BR3, BR4, BR5, BR6, BR7, SE20 and the surrounding area, including Beckenham, Catford and Lewisham
- Coast
- Bromley is well inland, around 25 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Bromley the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Bromley
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
Specification choices
Integrated opening vents
Top-hung or parallel-opening vents built into the curtain wall grid to provide natural ventilation without breaking the facade line.
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Curtain Walling in Bromley: questions
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
How long does a curtain walling project take?
Timescales depend on size and complexity. Design, approvals and fabrication of framing and glass usually take several weeks to a few months before installation starts. Installation then depends on the facade area, access and sequencing with other trades. Replacing individual units is much quicker once the glass is made. Your written quote sets out the expected programme.
Does new curtain walling need building regulations approval?
New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.
Do you cover Bromley for curtain walling?
Yes. We can quote for curtain walling across Bromley and the surrounding Greater London area, including postcode districts BR1, BR2, BR3, BR4 and BR5, and nearby Beckenham, Catford and Lewisham. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Bromley
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.