Risca · Gwent
Curtain Walling in Risca
Our glaziers install aluminium curtain walling and full-height glazed screens in Risca, coordinating with other trades and sealing every interface with the structure.
- NP11
- NP10
- Guide from £455 per m²
Glazed facade systems across Risca
Wind load on a facade rises with height, exposure and building shape, and it decides the mullion size, bracket design and glass thickness. Calculations for the specific site are part of the design, so a system suited to a sheltered ground-floor screen may not suit an exposed upper storey.
A stick system is built on site piece by piece. Aluminium mullions and transoms are fixed to the structure first, then the glass and infill panels go in, and finally the pressure plates and caps. It suits low-rise buildings and screens but needs access to both faces.
The look of the facade depends on how the glass is held. Capped systems clamp the glass with pressure plates hidden behind a visible cover cap, while structural silicone glazing bonds the glass to carrier frames so the outside reads as a smooth, almost frameless surface.
Curtain walling needs planned upkeep. Clean frames and glass regularly, keep drainage outlets clear, and inspect gaskets, seals and fixings for shrinkage, gaps or corrosion. Failed or misted sealed units can usually be replaced individually without removing the surrounding framing.
Included as standard
- Fabrication drawings and coordination with other trades
- Final inspection, clean and maintenance guidance
- Survey of openings, supporting structure and access
- Sealing, weathering and drainage details at all interfaces
Working in Risca
- Postcodes covered
- NP11, NP10 and the surrounding area, including Abercarn, Newport (Gwent) and Cwmbran
- Coast
- Risca sits roughly 9 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Facades near the sea face salt-laden wind and driving rain, which attack frame finishes and stress seals. Suitable coating specifications, regular washing, gasket checks and higher design wind loads for exposed sites all matter for curtain walling there.
- Daylight and sun
- In Risca the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in Wales
- In Wales, Approved Document N covers safety glazing: safety glass is needed in and around doors and in low-level glazing where people could walk into it.
Guide prices in Risca
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Like-for-like replacement windows on houses in Wales are usually permitted development, but flats, listed buildings and conservation areas can need permission. Check with the local planning authority.
Specification choices
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Opaque spandrel panels
Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Curtain Walling in Risca: questions
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
Does new curtain walling need building regulations approval?
New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.
Can a single broken glass unit in a curtain wall be replaced?
Usually, yes. In capped systems the cap and pressure plate are removed to release the glass, and a new unit is fitted and resealed. Structurally bonded glass needs the new unit bonding to its carrier, which takes more preparation. Height and access drive much of the work, so we survey the unit and access before quoting.
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
Do you cover Risca for curtain walling?
Yes. We can quote for curtain walling across Risca and the surrounding Gwent area, including postcode districts NP11 and NP10, and nearby Abercarn, Newport (Gwent) and Cwmbran. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Risca
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.