Sheffield · South Yorkshire
Curtain Walling in Sheffield
Curtain walling in Sheffield starts with a survey of the openings, structure and access, then a written quote that fixes the price for the system and glass shown.
- S1
- S3
- S2
- Guide from £455 per m²
Glazed facade systems in Sheffield: what to know
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
The price depends on the facade area, the system type, glass specification such as solar control or triple glazing, infill panels, opening vents, building height and access equipment, and design and testing requirements. Replacement units also depend on how the glass is retained. See the guide prices for typical ranges.
Wind load on a facade rises with height, exposure and building shape, and it decides the mullion size, bracket design and glass thickness. Calculations for the specific site are part of the design, so a system suited to a sheltered ground-floor screen may not suit an exposed upper storey.
Where a glazed screen must resist fire, the glass only performs as part of a fire-resistant system tested with its frame, seals, beads and fixings. Ratings use letters such as E for integrity and EI for integrity and insulation, and components must not be swapped without test evidence.
What's included
- Survey of openings, supporting structure and access
- Final inspection, clean and maintenance guidance
- Supply and installation of framing, glass and panels
- System selection and glass specification for the building
Sheffield at a glance
- Postcodes covered
- S1, S3, S2 and the surrounding area, including Rotherham, Dronfield and Chapeltown
- Coast
- Sheffield is well inland, around 62 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Sheffield the midwinter sun reaches about 13° above the horizon at noon, with roughly 7.2 hours of daylight, rising to about 60° and 16.8 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Sheffield
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Choosing your curtain walling
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Capped system
Glass clamped by pressure plates behind a visible external cap, available in different profiles and colours to emphasise the grid.
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Curtain Walling in Sheffield: questions
Can a single broken glass unit in a curtain wall be replaced?
Usually, yes. In capped systems the cap and pressure plate are removed to release the glass, and a new unit is fitted and resealed. Structurally bonded glass needs the new unit bonding to its carrier, which takes more preparation. Height and access drive much of the work, so we survey the unit and access before quoting.
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
Do you cover Sheffield for curtain walling?
Yes. We can quote for curtain walling across Sheffield and the surrounding South Yorkshire area, including postcode districts S1, S3 and S2, and nearby Rotherham, Dronfield and Chapeltown. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Sheffield
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.