Walsall · West Midlands
Curtain Walling in Walsall
We cover Walsall and West Midlands for curtain walling and glazed screens, from new commercial facades to replacing failed glass units in existing buildings.
- WS1
- WS2
- WS5
- Guide from £455 per m²
About glazed facade systems in Walsall
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
Where a glazed screen must resist fire, the glass only performs as part of a fire-resistant system tested with its frame, seals, beads and fixings. Ratings use letters such as E for integrity and EI for integrity and insulation, and components must not be swapped without test evidence.
The price depends on the facade area, the system type, glass specification such as solar control or triple glazing, infill panels, opening vents, building height and access equipment, and design and testing requirements. Replacement units also depend on how the glass is retained. See the guide prices for typical ranges.
Under the energy rules for new work in England, curtain walling performance is assessed for the whole system, including frames and opaque infill panels, not just the glass. Solar gain through the glass is also considered, so the glass choice balances heat loss, overheating and daylight.
What a typical job includes
- Survey of openings, supporting structure and access
- Final inspection, clean and maintenance guidance
- Fabrication drawings and coordination with other trades
- Sealing, weathering and drainage details at all interfaces
About Walsall for this job
- Postcodes covered
- WS1, WS2, WS5 and the surrounding area, including Bloxwich, Wednesbury and Aldridge
- Coast
- Walsall is well inland, around 93 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Walsall the midwinter sun reaches about 14° above the horizon at noon, with roughly 7.4 hours of daylight, rising to about 61° and 16.6 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Walsall
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
What you can choose
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Capped system
Glass clamped by pressure plates behind a visible external cap, available in different profiles and colours to emphasise the grid.
Stick curtain wall
Mullions and transoms assembled on site with glass and panels fitted afterwards, suited to low-rise buildings, entrances and ground-floor screens.
Curtain Walling in Walsall: questions
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
Does new curtain walling need building regulations approval?
New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
Do you cover Walsall for curtain walling?
Yes. We can quote for curtain walling across Walsall and the surrounding West Midlands area, including postcode districts WS1, WS2 and WS5, and nearby Bloxwich, Wednesbury and Aldridge. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Walsall
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.