Worcester · Worcestershire
Curtain Walling in Worcester
Planning a glazed facade in Worcester? Our glaziers can survey the building and quote for stick or unitised curtain walling specified for its height, exposure and energy needs.
- WR1
- WR2
- WR3
- WR4
- WR5
- WR8
- Guide from £455 per m²
Worcester: commercial glazed screens
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
Where a glazed screen must resist fire, the glass only performs as part of a fire-resistant system tested with its frame, seals, beads and fixings. Ratings use letters such as E for integrity and EI for integrity and insulation, and components must not be swapped without test evidence.
The price depends on the facade area, the system type, glass specification such as solar control or triple glazing, infill panels, opening vents, building height and access equipment, and design and testing requirements. Replacement units also depend on how the glass is retained. See the guide prices for typical ranges.
BS EN 13830 is the product standard for curtain walling. It treats the system as a kit, including its fixings, set from vertical up to 15 degrees off vertical. Sloping roof glazing and patent glazing fall outside it and are covered by other standards.
What you get
- Final inspection, clean and maintenance guidance
- Fabrication drawings and coordination with other trades
- System selection and glass specification for the building
- Supply and installation of framing, glass and panels
About Worcester for this job
- Postcodes covered
- WR1, WR2, WR3, WR4, WR5, WR8 and the surrounding area, including Droitwich, Great Malvern and Stourport-on-Severn
- Coast
- Worcester is well inland, around 46 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Worcester the midwinter sun reaches about 14° above the horizon at noon, with roughly 7.5 hours of daylight, rising to about 61° and 16.5 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Worcester
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Replacing windows and doors with similar ones is usually permitted development for houses in England. Flats, listed buildings and homes in conservation areas or covered by an Article 4 direction can need permission, so check with the council first.
Choosing your curtain walling
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Integrated opening vents
Top-hung or parallel-opening vents built into the curtain wall grid to provide natural ventilation without breaking the facade line.
Opaque spandrel panels
Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.
Curtain Walling in Worcester: questions
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
Does new curtain walling need building regulations approval?
New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.
Do you cover Worcester for curtain walling?
Yes. We can quote for curtain walling across Worcester and the surrounding Worcestershire area, including postcode districts WR1, WR2, WR3, WR4 and WR5, and nearby Droitwich, Great Malvern and Stourport-on-Severn. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Worcester
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.