Fareham · Hampshire
Frameless Glass in Fareham
Need a clear glass entrance for a shop or office in Fareham? We can quote for frameless doors with floor springs, locks and the markings that busy entrances need.
- PO16
- PO15
- PO14
- Guide from £795
Glass entrance doors in Fareham: what to know
Frameless doors run with small gaps at the edges and under the door, so they do not seal against sound or draughts the way a framed, gasketed door does. Clear seal strips can reduce the gaps, but where privacy or noise matters, an acoustic framed system may suit better.
A floor spring sits in a steel box set into the floor below the door, controlling closing speed and hold-open. It needs a recess cut into the screed, so it is far simpler to plan before tiles, stone or timber flooring are laid than to retrofit later.
Toughened glass cannot be cut, drilled or notched once it has been toughened. Holes for patch fittings, cut-outs for locks and handles, and any shaped corners are all made before toughening, which is why we template the opening first and the glass is made to order rather than cut on site.
A frameless door hangs on one of three main hardware types. Patch fittings clamp to the corners and pivot on a floor spring or top pivot, glass-to-wall hinges suit lighter internal doors, and sliding gear runs the panel along a track fixed above the opening.
What a typical job includes
- Templating for made-to-measure toughened glass
- Hinges, patch fittings, floor spring or sliding gear
- Manifestation where needed, final clean and care advice
- Holes and cut-outs made at the factory before toughening
About Fareham for this job
- Postcodes covered
- PO16, PO15, PO14 and the surrounding area, including Gosport, Portsmouth and Waterlooville
- Coast
- Fareham is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. External frameless entrances near the sea face salt spray on patch fittings, pivots and floor spring covers, which can mark or pit finishes over time. Hardware suited to exposed sites, and rinsing fittings during routine cleaning, help them stay smooth and presentable.
- Daylight and sun
- In Fareham the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 63° and 16.3 hours in midsummer. Clear frameless doors and screens pass daylight deep into hallways and inner rooms. Where a screen faces low winter sun, glare and reflections can be strong, so satin bands or tinted glass can help, while low-iron glass keeps pale colours true.
- Access and setting
- Older cottages and farmhouses rarely have square openings or level floors, so templating matters even more for frameless glass. Floors may also lack the depth for a floor spring, in which case top-hung sliding gear or wall hinges can suit better.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Fareham
| Typical job | Guide price inc VAT |
|---|---|
| Frameless glass door with fittings | £1,295 – £1,895 |
| Door with fixed side screen | £2,195 – £3,195 |
| Fixed frameless screen, about 2 m² | £795 – £1,095 |
Get a guide price for your size
For shops and other non-domestic buildings in England, Approved Document M covers accessible entrances, and Approved Document K requires large areas of glass that people could walk into to carry manifestation (visible markings).
Choosing your frameless glass
Hardware finishes
Patch fittings, handles and hinges in satin or polished stainless steel, black or other finishes to match the room or shopfront.
Pivot door with patches
Corner patch fittings with a floor spring or pivot, the usual choice for shop and office entrances and wide internal doors that need controlled closing.
Glass-to-wall hinged door
Hinges clamp the glass directly to a wall or fixed glass panel. Suits lighter internal doors where there is no room for a floor spring.
Frameless Glass in Fareham: questions
What happens if a frameless glass door breaks?
Toughened glass breaks into small, blunt pieces rather than large shards, so the door will need to be fully replaced rather than repaired. We can make the opening safe and secure in the meantime, then remake the panel from the original measurements or a fresh template, with holes and cut-outs formed before toughening.
Can a frameless glass door be locked?
Yes. A patch lock at the bottom of the door shoots a bolt into a keep in the floor, and a centre lock can join a pair of doors. A glass door does not offer the same resistance as a solid door, so for external entrances you may also want shutters, an alarm or laminated security glass in adjoining screens.
Do frameless glass doors have to be safety glass?
Yes. Glass in doors is a critical location, so in England it must meet the impact requirements in Approved Document K, and frameless doors are made from toughened safety glass to suit. Toughened glass also lets the door carry its own hinges and handles. Other UK nations have equivalent guidance, and we specify the glass to suit where you are.
What thickness of glass is used for frameless glass doors?
Frameless doors usually use 10mm or 12mm toughened safety glass. The thicker glass is generally used for taller or wider doors and for busy commercial entrances, while 10mm often suits internal doors in homes. The hardware maker's limits for panel weight and size also guide the choice, and we confirm the thickness in your written quote.
Do you cover Fareham for frameless glass?
Yes. We can quote for frameless glass across Fareham and the surrounding Hampshire area, including postcode districts PO16, PO15 and PO14, and nearby Gosport, Portsmouth and Waterlooville. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Fareham
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.