Faversham · Kent
Glass Roofs in Faversham
Our glaziers install glass roofs across Faversham, coordinating with your builder or engineer, lifting each unit into place and sealing every joint.
- ME13
- Guide from £1,095 per m²
Structural glass roof in Faversham: what to know
Overhead glass in a glass roof is generally specified with a laminated inner pane. If the inner glass breaks, the interlayer holds the fragments together instead of letting them fall into the room. BS 5516-2 is the British Standard code of practice for sloping and overhead glazing.
In England, Approved Document L limits how much of an extension can be glazed when the simple standard route is used. Large glass roofs often go beyond that limit, so energy calculations are usually needed to show the extension still complies, and building control checks them.
Overhead glass collects heat in summer. Solar-control coatings, low-E coatings and fritted patterns reduce heat and glare under south and west-facing roofs, while opening rooflights or vents elsewhere help warm air escape. Self-cleaning outer coatings reduce how often the glass needs washing.
Fixed frameless rooflights sit on a flat roof upstand with the glass edge overhanging the kerb, so from inside you see only sky and plaster. The upstand must be level, insulated and weathered into the roof covering, and the roof needs a fall so water drains off the glass.
What a typical job includes
- Coordination with engineers or builders where required
- Site survey and structural assessment of supports
- Lifting, positioning and fixing of every glass unit
- Glass specification with laminated make-up and coatings
Faversham at a glance
- Postcodes covered
- ME13 and the surrounding area, including Whitstable, Sittingbourne and Canterbury
- Coast
- Faversham is about 4 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Glass roofs near the coast collect salt film that self-cleaning coatings may not fully remove, so occasional rinsing helps. Exposed sites face higher wind uplift, which affects glass thickness and fixings, and any metal supports need coatings or grades suited to salt air.
- Daylight and sun
- In Faversham the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Overhead glass admits far more daylight than vertical glazing, especially in summer when the sun is high. South-facing glass roofs usually need solar-control coatings or fritting, while north-facing roofs can use clearer low-E glass to maximise winter light.
- Access and setting
- Rural sites may have long or narrow access tracks that limit crane positions and panel sizes, so access is surveyed early. Exposed locations face higher wind and snow loads, and leaves and debris from nearby trees mean gutters need regular clearing.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Faversham
| Typical job | Guide price inc VAT |
|---|---|
| Frameless glass roof, per m² | £1,095 – £1,795 |
| Walk-on glass panel, per m² | £1,495 – £2,395 |
Get a guide price for your size
Replacing windows and doors with similar ones is usually permitted development for houses in England. Flats, listed buildings and homes in conservation areas or covered by an Article 4 direction can need permission, so check with the council first.
What you can choose
Solar-control coatings
Coatings or fritted patterns that reduce heat gain and glare under overhead glass on sunny elevations.
Walk-on rooflight
A multi-layer laminated glass panel set into a roof terrace or flat roof, with an anti-slip surface for foot traffic.
Side-return glass roof
Large glass units spanning from the house wall to the boundary, supported on glass beams or slim steel, for extended kitchens.
Glass Roofs in Faversham: questions
Is a glass roof safe if the glass breaks?
A properly specified glass roof is designed so that a broken pane stays in place. The inner pane is laminated, so fragments remain bonded to the interlayer instead of falling into the room. The glass thickness, supports and edge details are designed for the expected loads, including snow, wind and maintenance access.
What is the difference between a glass roof and a roof lantern?
A glass roof replaces most or all of a roof with large structural glass units on minimal supports, giving a near frameless view of the sky. A roof lantern is a framed, pitched glazed structure that sits on an upstand within a solid flat roof. Glass roofs suit side returns and link extensions; lanterns suit openings in flat roofs.
How is a glass roof installed?
A glass roof is installed onto supports already built and checked, such as walls, steel beams, glass beams or upstands. The glass units are lifted with a crane, glass robot or vacuum lifters, set onto gaskets or setting blocks, fixed and then weather sealed. Most domestic roofs are installed in a day or two once supports are ready.
Does a glass roof need building regulations approval?
Yes. A new glass roof, frameless rooflight or walk-on panel is building work that normally needs approval through building control, covering structure, energy performance and fire performance near a boundary. Highly glazed extensions often need energy calculations to show compliance. The rules differ between England, Wales, Scotland and Northern Ireland, and we explain the route for your project.
Do you cover Faversham for glass roofs?
Yes. We can quote for glass roofs across Faversham and the surrounding Kent area, including postcode districts ME13, and nearby Whitstable, Sittingbourne and Canterbury. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Faversham
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.