Dundee · Angus & Dundee
Misted Glass Repair in Dundee
Is there fog between the panes of your windows in Dundee? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- DD1
- DD2
- DD3
- DD4
- DD5
- Guide from £155
Blown double glazing units for homes and businesses in Dundee
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
Some services offer to drill the glass, flush the cavity and add a vent instead of replacing the unit. This can improve the look, but it does not restore the original seal, and any gas fill that helped the unit insulate has already been lost. Replacement restores a sealed cavity.
Early seal failure often shows only on cold mornings or after rain and clears during the day. As the desiccant fills, the mist lasts longer and white mineral staining can form on the inner faces. Staining inside the unit cannot be removed by cleaning from either side.
What a typical job includes
- Fitting on packers with drainage slots checked
- Made-to-measure replacement units matching your windows
- Measurement of each failed sealed unit
- Survey to confirm the mist is inside the unit
Working in Dundee
- Postcodes covered
- DD1, DD2, DD3, DD4, DD5 and the surrounding area, including Carnoustie, St Andrews and Forfar
- Coast
- Dundee is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Dundee the midwinter sun reaches about 10° above the horizon at noon, with roughly 6.6 hours of daylight, rising to about 57° and 17.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in Scotland
- Section 4 (Safety) of the Scottish Technical Handbooks covers glazing that people could collide with, such as glass in and beside doors and low-level glazing, where safety glass is needed.
Guide prices in Dundee
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Section 6 (Energy) of the Scottish Technical Handbooks sets the thermal performance that replacement windows, doors and rooflights should achieve.
Specification choices
Georgian bar or leaded
Decorative bars or lead designs remade to match the originals so the new unit lines up with neighbouring windows.
Low-E upgrade unit
A coated pane and gas-filled cavity that reduce heat loss compared with older plain glass units, fitted in the same frame.
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Misted Glass Repair in Dundee: questions
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
Will a new unit match my other windows?
It can. The glazier records the unit thickness, spacer bar colour, any Georgian bars or leaded designs, and the obscure glass pattern if there is one. Most details can be matched closely. If an obscure pattern has been discontinued, the quote offers the closest available alternative so you can decide before anything is ordered.
How can I stop new sealed units misting early?
Keep the drainage slots at the bottom of the frame clear, so rainwater does not sit around the unit edges. Avoid pressure washing the seals, and do not paint over glazing gaskets. Check that opening sashes close properly, as a dropped sash can stress the unit. Report any cracked beads or failed gaskets early.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
Do you cover Dundee for misted glass repair?
Yes. We can quote for misted glass repair across Dundee and the surrounding Angus & Dundee area, including postcode districts DD1, DD2, DD3, DD4 and DD5, and nearby Carnoustie, St Andrews and Forfar. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Dundee
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.