Cambridge · Cambridgeshire
Misted Glass Repair in Cambridge
Is there fog between the panes of your windows in Cambridge? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- CB2
- CB4
- CB1
- Guide from £155
Blown double glazing units across Cambridge
If the misted unit is in a door, beside a door or low down near the floor, the replacement should be safety glass. In England, Approved Document K sets out these critical locations, and the replacement unit should meet them even if the original glass did not.
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
Check the paperwork for your windows before booking. Many sealed units come with a manufacturer guarantee against misting, and if your windows are still covered, the original installer or manufacturer may be responsible for replacing the failed unit under its terms.
Included as standard
- Measurement of each failed sealed unit
- Removal of old units and cleaning of rebates
- Written quote fixing the price for the specification
- Fitting on packers with drainage slots checked
Working in Cambridge
- Postcodes covered
- CB2, CB4, CB1 and the surrounding area, including St Ives (Cambridgeshire), Newmarket and Ely
- Coast
- Cambridge is well inland, around 66 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Cambridge the midwinter sun reaches about 14° above the horizon at noon, with roughly 7.5 hours of daylight, rising to about 61° and 16.5 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Cambridge
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Options to choose between
Obscure glass unit
Patterned glass for bathrooms, landings and front doors, chosen to match existing obscure panes or to add privacy.
Georgian bar or leaded
Decorative bars or lead designs remade to match the originals so the new unit lines up with neighbouring windows.
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Misted Glass Repair in Cambridge: questions
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
How can I stop new sealed units misting early?
Keep the drainage slots at the bottom of the frame clear, so rainwater does not sit around the unit edges. Avoid pressure washing the seals, and do not paint over glazing gaskets. Check that opening sashes close properly, as a dropped sash can stress the unit. Report any cracked beads or failed gaskets early.
Are misted units covered by a guarantee?
Often they are, for a period after installation. Many sealed unit manufacturers guarantee against misting, and the terms are set out in the paperwork from the original installer. If your units are still covered, contact that installer first. Units we supply carry manufacturer guarantees, and the terms are confirmed in writing with your quote.
How much does it cost to replace a misted sealed unit?
The cost depends on the size of the unit, the glass type, any Georgian bars, leaded or obscure features, how many units are done together, and access to the window. Larger units, safety glass and upper-floor windows cost more. See the guide prices for typical sizes, then get a written quote for your exact windows.
Do you cover Cambridge for misted glass repair?
Yes. We can quote for misted glass repair across Cambridge and the surrounding Cambridgeshire area, including postcode districts CB2, CB4 and CB1, and nearby St Ives (Cambridgeshire), Newmarket and Ely. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Cambridge
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.