Ealing · Greater London
Misted Glass Repair in Ealing
Our glaziers cover Ealing for misted window repairs, checking frames and drainage at the survey so the new sealed units are fitted correctly.
- W3
- W5
- W7
- W13
- Guide from £155
About foggy window replacement in Ealing
If the misted unit is in a door, beside a door or low down near the floor, the replacement should be safety glass. In England, Approved Document K sets out these critical locations, and the replacement unit should meet them even if the original glass did not.
Condensation on the room-side surface of the glass is not the same problem. It usually comes from humid indoor air meeting a cold pane and can be wiped away. Only mist trapped between the two panes means the sealed unit itself has failed and needs replacing.
Early seal failure often shows only on cold mornings or after rain and clears during the day. As the desiccant fills, the mist lasts longer and white mineral staining can form on the inner faces. Staining inside the unit cannot be removed by cleaning from either side.
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
What's included
- Fitting on packers with drainage slots checked
- Made-to-measure replacement units matching your windows
- Measurement of each failed sealed unit
- Removal of old units and cleaning of rebates
Working in Ealing
- Postcodes covered
- W3, W5, W7, W13 and the surrounding area, including Acton, Greenford and Chiswick
- Coast
- Ealing is well inland, around 47 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Ealing the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Ealing
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Obscure glass unit
Patterned glass for bathrooms, landings and front doors, chosen to match existing obscure panes or to add privacy.
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Misted Glass Repair in Ealing: questions
Does misted double glazing lose heat?
A misted unit usually insulates less well than when it was new, because any insulating gas in the cavity has escaped and been replaced with damp air. The mist itself also reduces clarity. Replacing the unit restores a sealed cavity, and choosing a low-E unit can improve on the original performance where the old unit was plain glass.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
Can you clean the inside of a misted double glazing unit?
Not without breaking the seal. Some firms drill the glass, flush the cavity and fit a small vent, which can clear the mist for a while. It does not restore an airtight seal or gas fill, and white staining may not fully clear. Replacing the unit is the reliable way to restore a clear, sealed cavity.
Do you cover Ealing for misted glass repair?
Yes. We can quote for misted glass repair across Ealing and the surrounding Greater London area, including postcode districts W3, W5, W7 and W13, and nearby Acton, Greenford and Chiswick. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Ealing
Misted Glass Repair nearby
Get a written quote in Ealing
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.