Kensington · Greater London
Misted Glass Repair in Kensington
Our glaziers cover Kensington for misted window repairs, checking frames and drainage at the survey so the new sealed units are fitted correctly.
- SW3
- SW5
- SW7
- SW10
- W8
- W10
- Guide from £155
Blown double glazing units in Kensington: what to know
If the misted unit is in a door, beside a door or low down near the floor, the replacement should be safety glass. In England, Approved Document K sets out these critical locations, and the replacement unit should meet them even if the original glass did not.
Check the paperwork for your windows before booking. Many sealed units come with a manufacturer guarantee against misting, and if your windows are still covered, the original installer or manufacturer may be responsible for replacing the failed unit under its terms.
A misted unit is a good opportunity to upgrade an older plain glass unit to one with a low-emissivity coating and gas fill. The new unit reduces heat loss through the glass and keeps the room-side pane warmer, without any change to the frame.
The price of replacing misted units depends on the size of each unit, the glass specification, any bars or decorative features, how many units are done together, and access. Several units on one visit usually cost less each than separate visits for single windows.
What's included
- Removal of old units and cleaning of rebates
- Measurement of each failed sealed unit
- Fitting on packers with drainage slots checked
- Survey to confirm the mist is inside the unit
Local details for Kensington
- Postcodes covered
- SW3, SW5, SW7, SW10, W8, W10, W11 and the surrounding area, including Shepherds Bush, Hammersmith and Chelsea
- Coast
- Kensington is well inland, around 39 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Kensington the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Kensington
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
What you can choose
Low-E upgrade unit
A coated pane and gas-filled cavity that reduce heat loss compared with older plain glass units, fitted in the same frame.
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Obscure glass unit
Patterned glass for bathrooms, landings and front doors, chosen to match existing obscure panes or to add privacy.
Misted Glass Repair in Kensington: questions
Does misted double glazing lose heat?
A misted unit usually insulates less well than when it was new, because any insulating gas in the cavity has escaped and been replaced with damp air. The mist itself also reduces clarity. Replacing the unit restores a sealed cavity, and choosing a low-E unit can improve on the original performance where the old unit was plain glass.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
Can misted double glazing be fixed without replacing the window?
Yes. In most cases only the sealed unit needs replacing, not the frame. The glazier removes the beads, lifts out the misted unit and fits a new one made to the same thickness. Your frames, hinges, handles and locks stay as they are, provided they are in good condition, which the glazier checks at the survey.
How can I stop new sealed units misting early?
Keep the drainage slots at the bottom of the frame clear, so rainwater does not sit around the unit edges. Avoid pressure washing the seals, and do not paint over glazing gaskets. Check that opening sashes close properly, as a dropped sash can stress the unit. Report any cracked beads or failed gaskets early.
Do you cover Kensington for misted glass repair?
Yes. We can quote for misted glass repair across Kensington and the surrounding Greater London area, including postcode districts SW3, SW5, SW7, SW10 and W8, and nearby Shepherds Bush, Hammersmith and Chelsea. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Kensington
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.