Chatham · Kent
Misted Glass Repair in Chatham
Is there fog between the panes of your windows in Chatham? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- ME4
- ME7
- ME1
- Guide from £155
Foggy window replacement across Chatham
The price of replacing misted units depends on the size of each unit, the glass specification, any bars or decorative features, how many units are done together, and access. Several units on one visit usually cost less each than separate visits for single windows.
Check the paperwork for your windows before booking. Many sealed units come with a manufacturer guarantee against misting, and if your windows are still covered, the original installer or manufacturer may be responsible for replacing the failed unit under its terms.
Once the seal has failed, any argon or other insulating gas in the cavity has escaped and been replaced by ordinary damp air. The unit insulates less well than when it was new, and moisture inside can gradually leave deposits that dull the glass.
A new unit has to match the overall thickness of the old one so it sits in the existing rebate and takes the original beads. The glazier also notes any Georgian bars, leaded designs or obscure patterns so the replacement matches the other windows in the room.
Included as standard
- Written quote fixing the price for the specification
- Measurement of each failed sealed unit
- Survey to confirm the mist is inside the unit
- Removal of old units and cleaning of rebates
About Chatham for this job
- Postcodes covered
- ME4, ME7, ME1 and the surrounding area, including Gillingham, Rochester and Strood
- Coast
- Chatham is about 4 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Chatham the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Chatham
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Misted Glass Repair in Chatham: questions
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
Are misted units covered by a guarantee?
Often they are, for a period after installation. Many sealed unit manufacturers guarantee against misting, and the terms are set out in the paperwork from the original installer. If your units are still covered, contact that installer first. Units we supply carry manufacturer guarantees, and the terms are confirmed in writing with your quote.
Can you clean the inside of a misted double glazing unit?
Not without breaking the seal. Some firms drill the glass, flush the cavity and fit a small vent, which can clear the mist for a while. It does not restore an airtight seal or gas fill, and white staining may not fully clear. Replacing the unit is the reliable way to restore a clear, sealed cavity.
Do you cover Chatham for misted glass repair?
Yes. We can quote for misted glass repair across Chatham and the surrounding Kent area, including postcode districts ME4, ME7 and ME1, and nearby Gillingham, Rochester and Strood. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Chatham
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.