Telford · Shropshire
Misted Glass Repair in Telford
Is there fog between the panes of your windows in Telford? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- TF4
- Guide from £155
Blown double glazing units in Telford
Once the seal has failed, any argon or other insulating gas in the cavity has escaped and been replaced by ordinary damp air. The unit insulates less well than when it was new, and moisture inside can gradually leave deposits that dull the glass.
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
Some services offer to drill the glass, flush the cavity and add a vent instead of replacing the unit. This can improve the look, but it does not restore the original seal, and any gas fill that helped the unit insulate has already been lost. Replacement restores a sealed cavity.
Common causes of seal failure include water sitting in the frame rebate because drainage holes are blocked, units fitted without correct packers, strong sun on dark frames, and age. Clearing the drainage slots in the frame helps protect the new unit from the same problem.
What's included
- Survey to confirm the mist is inside the unit
- Measurement of each failed sealed unit
- Fitting on packers with drainage slots checked
- Written quote fixing the price for the specification
Local details for Telford
- Postcodes covered
- TF4 and the surrounding area, including Wellington, Bridgnorth and Shrewsbury
- Coast
- Telford is well inland, around 74 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Telford the midwinter sun reaches about 14° above the horizon at noon, with roughly 7.4 hours of daylight, rising to about 61° and 16.6 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Telford
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
What you can choose
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Obscure glass unit
Patterned glass for bathrooms, landings and front doors, chosen to match existing obscure panes or to add privacy.
Misted Glass Repair in Telford: questions
Will a new unit match my other windows?
It can. The glazier records the unit thickness, spacer bar colour, any Georgian bars or leaded designs, and the obscure glass pattern if there is one. Most details can be matched closely. If an obscure pattern has been discontinued, the quote offers the closest available alternative so you can decide before anything is ordered.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
How much does it cost to replace a misted sealed unit?
The cost depends on the size of the unit, the glass type, any Georgian bars, leaded or obscure features, how many units are done together, and access to the window. Larger units, safety glass and upper-floor windows cost more. See the guide prices for typical sizes, then get a written quote for your exact windows.
Do you cover Telford for misted glass repair?
Yes. We can quote for misted glass repair across Telford and the surrounding Shropshire area, including postcode districts TF4, and nearby Wellington, Bridgnorth and Shrewsbury. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Telford
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.