Portsmouth · Hampshire
Replacement Glass in Portsmouth
If a pane in Portsmouth is cracked, scratched or not up to current safety rules, our glaziers can measure it and supply a made-to-order replacement.
- PO1
- PO5
- PO2
- Guide from £135
Glass replacement for windows in Portsmouth: what to know
In England, Approved Document K treats glass in a door or within 300mm of a door edge, up to 1500mm above the floor, and any other glass within 800mm of the floor as critical locations. Replacement glass in these areas should be safety glass, even where the old pane was not.
When a double glazed unit sits in a critical location, both panes need to be safety glass, not just the one facing the room. A unit with toughened glass on one side and ordinary float glass on the other does not give safe breakage from both directions.
Units with Georgian bars or leaded designs can be remade to match the originals. The glazier notes the bar width, colour and layout, or the lead pattern, so the new unit lines up with neighbouring windows. Bars fitted inside the cavity are protected from dirt and need no separate cleaning.
Safety glass should carry a permanent mark, usually etched in one corner, that stays visible once the glass is fitted. The mark identifies the maker or supplier and the standard it meets, such as BS EN 12150 for toughened glass or a BS EN 12600 impact class.
What you get
- Removal of old glass and packaging from site
- Survey and measurement of the existing glass or unit
- Written quote fixing the price for the specification
- Removal of the old pane and cleaning of the rebate

About Portsmouth for this job
- Postcodes covered
- PO1, PO5, PO2 and the surrounding area, including Gosport, Fareham and Ryde
- Coast
- Portsmouth is about 2 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Near the coast, salt air and wind-driven rain test the seals around replacement glass. Good bedding, correct packers and sound beads matter more, and stainless or coated fixings resist corrosion. Exposed panes may also need thicker glass to cope with wind load.
- Daylight and sun
- In Portsmouth the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 63° and 16.3 hours in midsummer. On south and west elevations, a solar control or low-E coating changes how much heat and glare new glass lets in. North-facing rooms usually benefit more from glass that keeps heat in while admitting as much daylight as possible.
- Access and setting
- In towns and cities, replacing glass in flats or above shops often means planning parking, stair access and lifting large units safely. Laminated glass suits ground-floor windows, acoustic glass helps on busy roads, and conservation areas may need matching patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Portsmouth
| Typical job | Guide price inc VAT |
|---|---|
| Small double glazed unit, 500 × 700 mm | £135 – £175 |
| Standard unit, 600 × 900 mm | £165 – £205 |
| Large unit, 1200 × 1200 mm | £285 – £365 |
| Toughened unit for a door, 750 × 1800 mm | £345 – £435 |
| Triple glazed unit, 600 × 900 mm | £235 – £305 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Choosing your replacement glass
Standard double glazed unit
Two panes of float glass with a sealed cavity, suitable where safety glass is not required and no special performance is needed.
Toughened safety glass
Heat-treated glass that breaks into small, relatively blunt pieces, used in doors, low-level panes and other critical locations.
Acoustic laminated glass
Laminated glass with a sound-dampening interlayer, often combined with unequal pane thicknesses to reduce traffic and street noise.
Replacement Glass in Portsmouth: questions
Do I need safety glass in my replacement window?
You do if the glass is in a critical location. In England, that means glass in doors and within 300mm of a door edge, up to 1500mm above floor level, and other glass within 800mm of the floor. Elsewhere in the UK the rules are similar, but the detail differs between nations. The glazier checks each location at the survey.
Should I upgrade to low-E glass when replacing a unit?
If the existing unit is plain float glass, a low-emissivity unit is worth considering because it reduces heat loss through the glass and keeps the inner pane warmer, which can reduce condensation on the room side. It fits the same frame, provided the overall thickness matches. The quote can show standard and low-E options side by side.
What is the difference between toughened and laminated replacement glass?
Toughened glass is heat treated so that, if it breaks, it crumbles into small, relatively blunt pieces and leaves the opening empty. Laminated glass has a plastic interlayer between two sheets that holds the pieces together, so the pane stays in the frame. Both count as safety glass when classified to the relevant standard, and laminated also helps with security and noise.
What affects the cost of replacement glass?
The main factors are the size of the pane, the glass type and thickness, and whether it is a single pane or a sealed unit. Toughened, laminated, acoustic and decorative units cost more than standard float glass. Access also matters, as upper-floor or awkward panes take longer to fit safely. See the guide prices for typical sizes, then get a written quote for your exact job.
Do you cover Portsmouth for replacement glass?
Yes. We can quote for replacement glass across Portsmouth and the surrounding Hampshire area, including postcode districts PO1, PO5 and PO2, and nearby Gosport, Fareham and Ryde. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Portsmouth
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.