Wells · Somerset
Replacement Glass in Wells
We can quote for replacement glass across Wells and Somerset, from a single cracked pane to a full set of upgraded low-E sealed units.
- BA5
- Guide from £135
About double glazing glass replacement in Wells
Many modern windows are internally beaded, which makes it harder to remove glass from outside. If your windows have external beads, ask about security glazing tape or clips when the glass is replaced, as these make it more difficult for beads to be prised off from outside.
When a double glazed unit sits in a critical location, both panes need to be safety glass, not just the one facing the room. A unit with toughened glass on one side and ordinary float glass on the other does not give safe breakage from both directions.
In England, Approved Document K treats glass in a door or within 300mm of a door edge, up to 1500mm above the floor, and any other glass within 800mm of the floor as critical locations. Replacement glass in these areas should be safety glass, even where the old pane was not.
Sealed units are made to measure, so the glazier records the width, height and overall thickness of the existing unit rather than the frame opening. The new unit has to match that thickness to sit correctly in the rebate and take the original beads, otherwise the seal and security of the pane suffer.
What you get
- Written quote fixing the price for the specification
- Survey and measurement of the existing glass or unit
- Removal of old glass and packaging from site
- Made-to-measure glass or sealed unit to suit the frame
About Wells for this job
- Postcodes covered
- BA5 and the surrounding area, including Shepton Mallet, Street and Frome
- Coast
- Wells is well inland, around 25 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Wells the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. On south and west elevations, a solar control or low-E coating changes how much heat and glare new glass lets in. North-facing rooms usually benefit more from glass that keeps heat in while admitting as much daylight as possible.
- Access and setting
- Older rural properties often have timber frames, small panes or leaded lights that need careful measuring and hand-made units. Panes in exposed spots may need thicker glass, and the survey confirms every detail so the fitting visit runs smoothly.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Wells
| Typical job | Guide price inc VAT |
|---|---|
| Small double glazed unit, 500 × 700 mm | £135 – £175 |
| Standard unit, 600 × 900 mm | £165 – £205 |
| Large unit, 1200 × 1200 mm | £285 – £365 |
| Toughened unit for a door, 750 × 1800 mm | £345 – £435 |
| Triple glazed unit, 600 × 900 mm | £235 – £305 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Georgian bar or leaded unit
Decorative bars or lead designs inside or on the glass, matched to existing windows for a consistent look across the property.
Triple glazed unit
Three panes and two cavities for extra insulation, where the frame's rebate is deep enough to take the thicker unit.
Toughened safety glass
Heat-treated glass that breaks into small, relatively blunt pieces, used in doors, low-level panes and other critical locations.
Replacement Glass in Wells: questions
What affects the cost of replacement glass?
The main factors are the size of the pane, the glass type and thickness, and whether it is a single pane or a sealed unit. Toughened, laminated, acoustic and decorative units cost more than standard float glass. Access also matters, as upper-floor or awkward panes take longer to fit safely. See the guide prices for typical sizes, then get a written quote for your exact job.
Can I replace a sealed unit myself?
Single panes in simple frames are sometimes replaced by confident DIYers, but sealed units and safety glass carry risks. A unit that is not packed correctly can make an opening sash drop or crack under load, and handling large panes is hazardous. A glazier also checks whether safety glass is required and that the new glass carries the correct marking.
Should I upgrade to low-E glass when replacing a unit?
If the existing unit is plain float glass, a low-emissivity unit is worth considering because it reduces heat loss through the glass and keeps the inner pane warmer, which can reduce condensation on the room side. It fits the same frame, provided the overall thickness matches. The quote can show standard and low-E options side by side.
How long does it take to get replacement glass fitted?
There are usually two stages: a survey to measure, then a fitting visit once the glass has been made. Toughened glass and sealed units are manufactured to order, so they cannot be cut from stock while the glazier waits. Fitting itself usually takes a short time per window. Your quote will set out when the glass is expected, and we will tell you honestly when a glazier can attend.
Do you cover Wells for replacement glass?
Yes. We can quote for replacement glass across Wells and the surrounding Somerset area, including postcode districts BA5, and nearby Shepton Mallet, Street and Frome. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Wells
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.