Horley · Surrey
Replacement Glass in Horley
Cracked or broken glass in Horley can usually be replaced without changing the frame, and our glaziers can quote for single panes and sealed units.
- RH6
- Guide from £135
Broken window glass repair for homes and businesses in Horley
Fitting a replacement unit is usually a short visit per window once the glass has been made. The beads are eased out, the old unit lifted out, the rebate cleaned, and the new unit set on glazing packers to support its weight and keep any opening sash square before the beads go back.
Safety glass should carry a permanent mark, usually etched in one corner, that stays visible once the glass is fitted. The mark identifies the maker or supplier and the standard it meets, such as BS EN 12150 for toughened glass or a BS EN 12600 impact class.
Swapping glass in an existing frame is normally treated as a repair rather than notifiable building work in England. Replacing the whole frame and opening parts is different and usually needs to be notified, either through building control or a competent person scheme such as FENSA or Certass.
Sealed units are made to measure, so the glazier records the width, height and overall thickness of the existing unit rather than the frame opening. The new unit has to match that thickness to sit correctly in the rebate and take the original beads, otherwise the seal and security of the pane suffer.
What's included
- Written quote fixing the price for the specification
- Removal of the old pane and cleaning of the rebate
- Made-to-measure glass or sealed unit to suit the frame
- Survey and measurement of the existing glass or unit
About Horley for this job
- Postcodes covered
- RH6 and the surrounding area, including Crawley, Redhill and Reigate
- Coast
- Horley is well inland, around 38 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Horley the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 62° and 16.3 hours in midsummer. On south and west elevations, a solar control or low-E coating changes how much heat and glare new glass lets in. North-facing rooms usually benefit more from glass that keeps heat in while admitting as much daylight as possible.
- Access and setting
- Older rural properties often have timber frames, small panes or leaded lights that need careful measuring and hand-made units. Panes in exposed spots may need thicker glass, and the survey confirms every detail so the fitting visit runs smoothly.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Horley
| Typical job | Guide price inc VAT |
|---|---|
| Small double glazed unit, 500 × 700 mm | £135 – £175 |
| Standard unit, 600 × 900 mm | £165 – £205 |
| Large unit, 1200 × 1200 mm | £285 – £365 |
| Toughened unit for a door, 750 × 1800 mm | £345 – £435 |
| Triple glazed unit, 600 × 900 mm | £235 – £305 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Acoustic laminated glass
Laminated glass with a sound-dampening interlayer, often combined with unequal pane thicknesses to reduce traffic and street noise.
Low-E energy unit
A coated pane and gas-filled cavity that reduce heat loss through the glass compared with older plain float glass units.
Toughened safety glass
Heat-treated glass that breaks into small, relatively blunt pieces, used in doors, low-level panes and other critical locations.
Replacement Glass in Horley: questions
Do I need safety glass in my replacement window?
You do if the glass is in a critical location. In England, that means glass in doors and within 300mm of a door edge, up to 1500mm above floor level, and other glass within 800mm of the floor. Elsewhere in the UK the rules are similar, but the detail differs between nations. The glazier checks each location at the survey.
Does replacing window glass need building regulations approval?
Replacing only the glass in an existing frame is normally treated as a repair in England and does not need to be notified. Replacing the whole window is different and must go through building control or a competent person scheme. Even for glass-only work, safety glass should be used in critical locations, and the detail of the rules differs between UK nations.
How long does it take to get replacement glass fitted?
There are usually two stages: a survey to measure, then a fitting visit once the glass has been made. Toughened glass and sealed units are manufactured to order, so they cannot be cut from stock while the glazier waits. Fitting itself usually takes a short time per window. Your quote will set out when the glass is expected, and we will tell you honestly when a glazier can attend.
Should I upgrade to low-E glass when replacing a unit?
If the existing unit is plain float glass, a low-emissivity unit is worth considering because it reduces heat loss through the glass and keeps the inner pane warmer, which can reduce condensation on the room side. It fits the same frame, provided the overall thickness matches. The quote can show standard and low-E options side by side.
Do you cover Horley for replacement glass?
Yes. We can quote for replacement glass across Horley and the surrounding Surrey area, including postcode districts RH6, and nearby Crawley, Redhill and Reigate. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Horley
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.