Call 0800 088 6248

Billingham · County Durham

Roof Lanterns in Billingham

Our glaziers fit roof lanterns across Billingham, glazing and sealing each unit onto its upstand and explaining any building regulations approval the work needs.

  • TS23
  • Guide from £1,095

Get your free quote

Start with your postcode. A glazier will be in touch to arrange a free survey.

By sending this form you agree we can contact you about this enquiry. See our privacy policy for how we use your details.

No obligation. Prefer to talk? Call 0800 088 6248 or WhatsApp us.

Flat roof skylight across Billingham

The Rooflight Association recommends laminated glass for the inner pane of glass rooflights, because laminated glass stays bonded together if it breaks instead of dropping fragments into the room below. Toughened inner panes are still used, but laminated is the safer choice over kitchens, stairs and seating areas.

In England, Approved Document L sets a limiting U-value of 2.2 W/m²K for rooflights, calculated in the horizontal position, for both new and existing homes. A kerb or upstand built on site should achieve 0.35 W/m²K or better. Ask for the lantern's declared horizontal U-value, not a vertical figure.

Warm, moist air rises and collects in a roof lantern, so condensation can form on cold winter mornings, especially over kitchens and bathrooms. Thermally broken frames, warm-edge spacers and good room ventilation reduce it, and opening vents in the lantern can release warm air in summer.

Roof lanterns are not designed to be walked on, so never stand or lean on the glass or bars. Cleaning and inspection should be done from safe access at the edge of the roof. Keep leaves and debris away from the upstand and roof outlets so water drains freely.

What's included

  • Fixing, glazing and sealing onto the prepared upstand
  • Removal and disposal of an old lantern or skylight
  • Survey of the roof, opening, upstand and drainage
  • Sealed double glazed units with laminated inner pane options
Roof lantern above a kitchen island in an open-plan extension

Billingham at a glance

Postcodes covered
TS23 and the surrounding area, including Stockton-on-Tees, Middlesbrough and Thornaby-on-Tees
Coast
Billingham sits roughly 8 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Coastal lanterns face salt deposits on the glass and frames and strong uplift from wind on exposed roofs. Marine-grade coatings, stainless fixings and secure fixing to a well-built upstand matter, and salt film may need rinsing more often than self-cleaning glass manages alone.
Daylight and sun
In Billingham the midwinter sun reaches about 12° above the horizon at noon, with roughly 7.0 hours of daylight, rising to about 59° and 17.0 hours in midsummer. Overhead glazing receives far more light than a wall window of the same size, especially when the sun is high in summer. South-facing lanterns may need solar-control glass, while low winter sun and north-facing rooms benefit from clear, high light-transmission low-E glass.
Access and setting
Rural roofs collect more leaves, moss and bird debris, so lanterns need clear upstand drainage and regular checks. Exposed sites see higher wind loads and driving rain, and older outbuildings may need the roof structure strengthening before a lantern is added.
Rules in England
Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.

Guide prices in Billingham

Guide prices inc VAT for typical jobs. Remote and island locations are quoted by arrangement. Your written quote fixes the price after measuring.
Typical jobGuide price inc VAT
Lantern 1500 × 1000 mm, fitted to a kerb£1,395 – £1,795
Lantern 2000 × 1000 mm£1,695 – £2,095
Lantern 3000 × 1500 mm£2,795 – £3,695
Flat glass rooflight 1000 × 1000 mm£1,095 – £1,395

Get a guide price for your size

In England, replacing a whole window, roof window or glazed external door is building work. It has to be notified to building control, either by an installer registered with a competent person scheme such as FENSA or Certass, or through a building notice to the council. Replacing only the glass in an existing frame is a repair and is not notifiable.

Specification choices

Frame colours

Powder-coated aluminium in grey, black, white or other RAL colours, often dual colour to suit the roof and the room.

Solar-control glass

Neutral or blue-tinted coatings that reduce heat build-up under south or west-facing lanterns while keeping daylight levels high.

Flat framed skylight

A low-profile framed rooflight on a flat roof upstand, fixed or opening, for bathrooms, landings and smaller rooms.

Roof Lanterns in Billingham: questions

How do I clean a roof lantern?

Self-cleaning coated glass lets rain lift most dirt, but a rinse with clean water in long dry spells helps. Clean from a safe position at the roof edge or from a suitable platform, never by standing on the lantern. Wipe the inside glass with mild soapy water, and keep leaves clear of the upstand and roof outlets.

Do I need planning permission for a roof lantern?

Sometimes. In England, rooflights on a house are usually permitted development if they project no more than 150mm above the roof plane and are no higher than the highest part of the roof. Raised lanterns often exceed that, and flats, listed buildings and conservation areas have extra controls, so check with your council first.

Will a roof lantern make my room too hot?

A roof lantern can add heat on sunny days, especially facing south or west, because overhead glass receives sun for much of the day. Solar-control glass, opening vents and blinds help keep the room comfortable. The glass is chosen at survey based on the lantern's size and orientation and how the room is used.

Why does my roof lantern get condensation?

Condensation forms when warm, moist air from cooking, bathing or drying clothes meets the colder glass and frames at high level. Older single glazed or non thermally broken lanterns suffer most. Thermally broken frames, warm-edge spacers, extractor fans and opening vents reduce it. Some condensation on very cold mornings is normal and clears as the room warms.

Do you cover Billingham for roof lanterns?

Yes. We can quote for roof lanterns across Billingham and the surrounding County Durham area, including postcode districts TS23, and nearby Stockton-on-Tees, Middlesbrough and Thornaby-on-Tees. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.

Get a written quote in Billingham

Free survey for new glazing, clear guide prices and one point of contact for every glazing job.

CallGet a quote