Call 0800 088 6248

Chester-le-Street · County Durham

Roof Lanterns in Chester-le-Street

A roof lantern in Chester-le-Street can flood a dark extension or kitchen with daylight from above, and our glaziers check the roof and upstand before you receive a fixed written quote.

  • DH2
  • Guide from £1,095

Get your free quote

Start with your postcode. A glazier will be in touch to arrange a free survey.

By sending this form you agree we can contact you about this enquiry. See our privacy policy for how we use your details.

No obligation. Prefer to talk? Call 0800 088 6248 or WhatsApp us.

Chester-le-Street: aluminium roof lantern

The Rooflight Association recommends laminated glass for the inner pane of glass rooflights, because laminated glass stays bonded together if it breaks instead of dropping fragments into the room below. Toughened inner panes are still used, but laminated is the safer choice over kitchens, stairs and seating areas.

Opening skylights and lantern vents can be manual or electrically operated, often with a rain sensor that closes them automatically when it starts to rain. Electric vents need a power supply planned before plastering, so the wiring route is agreed at survey when an opening option is chosen.

In England, a rooflight on a house is usually permitted development if it projects no more than 150mm beyond the roof plane and is no higher than the highest part of the roof. Raised lanterns often stand taller than that, so check with the council before ordering.

In England, Approved Document L sets a limiting U-value of 2.2 W/m²K for rooflights, calculated in the horizontal position, for both new and existing homes. A kerb or upstand built on site should achieve 0.35 W/m²K or better. Ask for the lantern's declared horizontal U-value, not a vertical figure.

What you get

  • Made-to-measure aluminium roof lantern or framed skylight
  • Survey of the roof, opening, upstand and drainage
  • Sealed double glazed units with laminated inner pane options
  • Removal and disposal of an old lantern or skylight
Roof lantern above a kitchen island in an open-plan extension

About Chester-le-Street for this job

Postcodes covered
DH2 and the surrounding area, including Washington, Houghton-le-Spring and Stanley
Coast
Chester-le-Street sits roughly 14 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Coastal lanterns face salt deposits on the glass and frames and strong uplift from wind on exposed roofs. Marine-grade coatings, stainless fixings and secure fixing to a well-built upstand matter, and salt film may need rinsing more often than self-cleaning glass manages alone.
Daylight and sun
In Chester-le-Street the midwinter sun reaches about 12° above the horizon at noon, with roughly 6.9 hours of daylight, rising to about 59° and 17.1 hours in midsummer. Overhead glazing receives far more light than a wall window of the same size, especially when the sun is high in summer. South-facing lanterns may need solar-control glass, while low winter sun and north-facing rooms benefit from clear, high light-transmission low-E glass.
Access and setting
Rural roofs collect more leaves, moss and bird debris, so lanterns need clear upstand drainage and regular checks. Exposed sites see higher wind loads and driving rain, and older outbuildings may need the roof structure strengthening before a lantern is added.
Rules in England
Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.

Guide prices in Chester-le-Street

Guide prices inc VAT for typical jobs. Remote and island locations are quoted by arrangement. Your written quote fixes the price after measuring.
Typical jobGuide price inc VAT
Lantern 1500 × 1000 mm, fitted to a kerb£1,395 – £1,795
Lantern 2000 × 1000 mm£1,695 – £2,095
Lantern 3000 × 1500 mm£2,795 – £3,695
Flat glass rooflight 1000 × 1000 mm£1,095 – £1,395

Get a guide price for your size

If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.

Specification choices

Solar-control glass

Neutral or blue-tinted coatings that reduce heat build-up under south or west-facing lanterns while keeping daylight levels high.

Flat framed skylight

A low-profile framed rooflight on a flat roof upstand, fixed or opening, for bathrooms, landings and smaller rooms.

Opening vents

Manual or electric vents in the lantern or skylight, with optional rain sensors that close them automatically in wet weather.

Roof Lanterns in Chester-le-Street: questions

Should the inner glass in a roof lantern be laminated?

Laminated inner glass is the safer choice and is recommended by the Rooflight Association. If a laminated pane breaks, the interlayer holds the pieces together, so glass is far less likely to fall into the room below. This matters most over kitchens, dining tables, stairs and seating, and it is offered as a standard option.

Does fitting a roof lantern need building regulations approval?

A new roof lantern or skylight generally needs building regulations approval, because the roof structure is cut and must be supported, and the unit must meet energy standards. Fire performance also matters near a boundary. Replacing a lantern on an existing sound upstand is simpler, and we explain which route applies at survey.

Can I replace my old polycarbonate roof lantern with glass?

Yes, in most cases. A glass lantern is heavier than polycarbonate, so the upstand and roof structure must be able to carry it. If the upstand is sound, level and the right size, a new aluminium lantern can usually sit on it. If not, the upstand is rebuilt first, which the survey will identify.

How long does it take to fit a roof lantern?

Fitting a roof lantern on a prepared upstand usually takes a day or less for a typical size, longer for large or complex shapes. The lantern is made to order first, and the lead time depends on its size, shape and colour. Building or rebuilding an upstand is separate roofing work that comes before fitting.

Do you cover Chester-le-Street for roof lanterns?

Yes. We can quote for roof lanterns across Chester-le-Street and the surrounding County Durham area, including postcode districts DH2, and nearby Washington, Houghton-le-Spring and Stanley. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.

Get a written quote in Chester-le-Street

Free survey for new glazing, clear guide prices and one point of contact for every glazing job.

CallGet a quote