Blairgowrie · Perth & Kinross
Roof Lanterns in Blairgowrie
Our glaziers fit roof lanterns across Blairgowrie, glazing and sealing each unit onto its upstand and explaining any building regulations approval the work needs.
- PH10
- Guide from £1,095
Roof lantern replacement in Blairgowrie
Roof lanterns are not designed to be walked on, so never stand or lean on the glass or bars. Cleaning and inspection should be done from safe access at the edge of the roof. Keep leaves and debris away from the upstand and roof outlets so water drains freely.
Cutting a new opening for a roof lantern or skylight usually means trimming joists or rafters, so the roof can carry the load around the hole. Building regulations approval is generally needed for a new rooflight, covering structure, energy performance and, near a boundary, fire performance.
The Rooflight Association recommends laminated glass for the inner pane of glass rooflights, because laminated glass stays bonded together if it breaks instead of dropping fragments into the room below. Toughened inner panes are still used, but laminated is the safer choice over kitchens, stairs and seating areas.
A roof lantern is assembled from an aluminium ridge, hip bars and glazing bars that hold sealed glass units on each pitch. It sits on an upstand built around the roof opening. The upstand should be level, weathered into the roof covering and insulated, because a poor upstand causes most leaks and cold spots.
Included as standard
- Removal and disposal of an old lantern or skylight
- Fixing, glazing and sealing onto the prepared upstand
- Survey of the roof, opening, upstand and drainage
- Written guarantee terms and manufacturer documentation
Working in Blairgowrie
- Postcodes covered
- PH10 and the surrounding area, including Perth, Dundee and Pitlochry
- Coast
- Blairgowrie is well inland, around 22 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Blairgowrie the midwinter sun reaches about 10° above the horizon at noon, with roughly 6.5 hours of daylight, rising to about 57° and 17.5 hours in midsummer. Overhead glazing receives far more light than a wall window of the same size, especially when the sun is high in summer. South-facing lanterns may need solar-control glass, while low winter sun and north-facing rooms benefit from clear, high light-transmission low-E glass.
- Access and setting
- Rural roofs collect more leaves, moss and bird debris, so lanterns need clear upstand drainage and regular checks. Exposed sites see higher wind loads and driving rain, and older outbuildings may need the roof structure strengthening before a lantern is added.
- Rules in Scotland
- Section 4 (Safety) of the Scottish Technical Handbooks covers glazing that people could collide with, such as glass in and beside doors and low-level glazing, where safety glass is needed.
Guide prices in Blairgowrie
| Typical job | Guide price inc VAT |
|---|---|
| Lantern 1500 × 1000 mm, fitted to a kerb | £1,395 – £1,795 |
| Lantern 2000 × 1000 mm | £1,695 – £2,095 |
| Lantern 3000 × 1500 mm | £2,795 – £3,695 |
| Flat glass rooflight 1000 × 1000 mm | £1,095 – £1,395 |
Get a guide price for your size
In Scotland, replacing windows or doors in a house like for like does not usually need a building warrant, but the work must still meet the building standards in the Technical Handbooks. Flats and listed buildings can differ, so check with the local authority.
Specification choices
Flat framed skylight
A low-profile framed rooflight on a flat roof upstand, fixed or opening, for bathrooms, landings and smaller rooms.
Rectangular hipped lantern
A long ridge with hipped ends, suiting most rectangular extensions and kitchens, sized to the opening and the room below.
Solar-control glass
Neutral or blue-tinted coatings that reduce heat build-up under south or west-facing lanterns while keeping daylight levels high.
Roof Lanterns in Blairgowrie: questions
Does fitting a roof lantern need building regulations approval?
A new roof lantern or skylight generally needs building regulations approval, because the roof structure is cut and must be supported, and the unit must meet energy standards. Fire performance also matters near a boundary. Replacing a lantern on an existing sound upstand is simpler, and we explain which route applies at survey.
Will a roof lantern make my room too hot?
A roof lantern can add heat on sunny days, especially facing south or west, because overhead glass receives sun for much of the day. Solar-control glass, opening vents and blinds help keep the room comfortable. The glass is chosen at survey based on the lantern's size and orientation and how the room is used.
What guarantee comes with a roof lantern?
Manufacturer guarantees apply to the frame, coating and sealed units, and the terms are confirmed in writing. The upstand and roof covering may be covered separately, depending on who builds them. Guarantee terms for the installation are set out in writing with your quote, so you know exactly what is covered before going ahead.
How do I clean a roof lantern?
Self-cleaning coated glass lets rain lift most dirt, but a rinse with clean water in long dry spells helps. Clean from a safe position at the roof edge or from a suitable platform, never by standing on the lantern. Wipe the inside glass with mild soapy water, and keep leaves clear of the upstand and roof outlets.
Do you cover Blairgowrie for roof lanterns?
Yes. We can quote for roof lanterns across Blairgowrie and the surrounding Perth & Kinross area, including postcode districts PH10, and nearby Perth, Dundee and Pitlochry. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Blairgowrie
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.