Call 0800 088 6248

Rutland · England

Roof Lanterns in Rutland

A roof lantern in Rutland can flood a dark extension or kitchen with daylight from above, and our glaziers check the roof and upstand before you receive a fixed written quote.

  • Guide from £1,095
  • 2 towns covered
  • Postcode areas LE

Get your free quote

Start with your postcode. A glazier will be in touch to arrange a free survey.

By sending this form you agree we can contact you about this enquiry. See our privacy policy for how we use your details.

No obligation. Prefer to talk? Call 0800 088 6248 or WhatsApp us.

Opening skylights in Rutland: what to know

The Rooflight Association recommends laminated glass for the inner pane of glass rooflights, because laminated glass stays bonded together if it breaks instead of dropping fragments into the room below. Toughened inner panes are still used, but laminated is the safer choice over kitchens, stairs and seating areas.

Roof lanterns are not designed to be walked on, so never stand or lean on the glass or bars. Cleaning and inspection should be done from safe access at the edge of the roof. Keep leaves and debris away from the upstand and roof outlets so water drains freely.

A roof lantern is assembled from an aluminium ridge, hip bars and glazing bars that hold sealed glass units on each pitch. It sits on an upstand built around the roof opening. The upstand should be level, weathered into the roof covering and insulated, because a poor upstand causes most leaks and cold spots.

Old polycarbonate or single glazed roof lanterns can be replaced with double glazed aluminium lanterns on the existing upstand, if the upstand is sound, level and the right size. Upstands that are rotten, uninsulated or out of level should be rebuilt first, which the survey identifies.

Roof lantern above a kitchen island in an open-plan extension

Towns we cover for roof lanterns in Rutland

Choose your town for local details, nearby areas and the postcode districts we cover.

What applies in Rutland

Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.

If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.

Rutland is inland, around 57 km from the nearest coast at its closest point, so salt exposure is rarely a factor.

Rural roofs collect more leaves, moss and bird debris, so lanterns need clear upstand drainage and regular checks. Exposed sites see higher wind loads and driving rain, and older outbuildings may need the roof structure strengthening before a lantern is added.

Guide prices

Guide prices inc VAT for typical jobs. Remote and island locations are quoted by arrangement. Your written quote fixes the price after measuring.
Typical jobGuide price inc VAT
Lantern 1500 × 1000 mm, fitted to a kerb£1,395 – £1,795
Lantern 2000 × 1000 mm£1,695 – £2,095
Lantern 3000 × 1500 mm£2,795 – £3,695
Flat glass rooflight 1000 × 1000 mm£1,095 – £1,395

Choosing your roof lanterns

Solar-control glass

Neutral or blue-tinted coatings that reduce heat build-up under south or west-facing lanterns while keeping daylight levels high.

Rectangular hipped lantern

A long ridge with hipped ends, suiting most rectangular extensions and kitchens, sized to the opening and the room below.

Flat framed skylight

A low-profile framed rooflight on a flat roof upstand, fixed or opening, for bathrooms, landings and smaller rooms.

Frame colours

Powder-coated aluminium in grey, black, white or other RAL colours, often dual colour to suit the roof and the room.

Roof Lanterns in Rutland: questions

Can I replace my old polycarbonate roof lantern with glass?

Yes, in most cases. A glass lantern is heavier than polycarbonate, so the upstand and roof structure must be able to carry it. If the upstand is sound, level and the right size, a new aluminium lantern can usually sit on it. If not, the upstand is rebuilt first, which the survey will identify.

How much does a roof lantern cost?

The cost of a roof lantern depends on its size and shape, the glass specification, frame colour, any opening vents, and whether the upstand exists or needs building. Access to the roof and lifting a large lantern also affect labour. See the guide prices for typical ranges; the written quote fixes the price for your exact specification.

How do I clean a roof lantern?

Self-cleaning coated glass lets rain lift most dirt, but a rinse with clean water in long dry spells helps. Clean from a safe position at the roof edge or from a suitable platform, never by standing on the lantern. Wipe the inside glass with mild soapy water, and keep leaves clear of the upstand and roof outlets.

Should the inner glass in a roof lantern be laminated?

Laminated inner glass is the safer choice and is recommended by the Rooflight Association. If a laminated pane breaks, the interlayer holds the pieces together, so glass is far less likely to fall into the room below. This matters most over kitchens, dining tables, stairs and seating, and it is offered as a standard option.

Which parts of Rutland do you cover for roof lanterns?

We cover the whole of Rutland, including Oakham and Uppingham, and postcode areas LE. Building rules for roof lanterns here follow the regulations for England. Enter your postcode on the quote form and we will confirm cover; then a glazier will arrange a free survey before giving you a written quote.

Get a written quote in Rutland

Free survey for new glazing, clear guide prices and one point of contact for every glazing job.

CallGet a quote