Esher · Surrey
Roof Lanterns in Esher
We cover Esher and the rest of Surrey for roof lantern supply and fitting, from small skylights over landings to large lanterns for open-plan kitchens.
- KT7
- KT10
- Guide from £1,095
Roof lantern replacement for homes and businesses in Esher
The Rooflight Association recommends laminated glass for the inner pane of glass rooflights, because laminated glass stays bonded together if it breaks instead of dropping fragments into the room below. Toughened inner panes are still used, but laminated is the safer choice over kitchens, stairs and seating areas.
A roof lantern is assembled from an aluminium ridge, hip bars and glazing bars that hold sealed glass units on each pitch. It sits on an upstand built around the roof opening. The upstand should be level, weathered into the roof covering and insulated, because a poor upstand causes most leaks and cold spots.
Old polycarbonate or single glazed roof lanterns can be replaced with double glazed aluminium lanterns on the existing upstand, if the upstand is sound, level and the right size. Upstands that are rotten, uninsulated or out of level should be rebuilt first, which the survey identifies.
In England, a rooflight on a house is usually permitted development if it projects no more than 150mm beyond the roof plane and is no higher than the highest part of the roof. Raised lanterns often stand taller than that, so check with the council before ordering.
What a typical job includes
- Written guarantee terms and manufacturer documentation
- Made-to-measure aluminium roof lantern or framed skylight
- Removal and disposal of an old lantern or skylight
- Fixing, glazing and sealing onto the prepared upstand
Local details for Esher
- Postcodes covered
- KT7, KT10 and the surrounding area, including Walton-on-Thames, Hampton and Sunbury-on-Thames
- Coast
- Esher is well inland, around 52 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Esher the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Overhead glazing receives far more light than a wall window of the same size, especially when the sun is high in summer. South-facing lanterns may need solar-control glass, while low winter sun and north-facing rooms benefit from clear, high light-transmission low-E glass.
- Access and setting
- Rural roofs collect more leaves, moss and bird debris, so lanterns need clear upstand drainage and regular checks. Exposed sites see higher wind loads and driving rain, and older outbuildings may need the roof structure strengthening before a lantern is added.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Esher
| Typical job | Guide price inc VAT |
|---|---|
| Lantern 1500 × 1000 mm, fitted to a kerb | £1,395 – £1,795 |
| Lantern 2000 × 1000 mm | £1,695 – £2,095 |
| Lantern 3000 × 1500 mm | £2,795 – £3,695 |
| Flat glass rooflight 1000 × 1000 mm | £1,095 – £1,395 |
Get a guide price for your size
In England, replacing a whole window, roof window or glazed external door is building work. It has to be notified to building control, either by an installer registered with a competent person scheme such as FENSA or Certass, or through a building notice to the council. Replacing only the glass in an existing frame is a repair and is not notifiable.
Choosing your roof lanterns
Frame colours
Powder-coated aluminium in grey, black, white or other RAL colours, often dual colour to suit the roof and the room.
Square or octagonal lantern
A pyramid or eight-sided design that suits square rooms, orangeries and spaces where a central focal point is wanted.
Flat framed skylight
A low-profile framed rooflight on a flat roof upstand, fixed or opening, for bathrooms, landings and smaller rooms.
Roof Lanterns in Esher: questions
Why does my roof lantern get condensation?
Condensation forms when warm, moist air from cooking, bathing or drying clothes meets the colder glass and frames at high level. Older single glazed or non thermally broken lanterns suffer most. Thermally broken frames, warm-edge spacers, extractor fans and opening vents reduce it. Some condensation on very cold mornings is normal and clears as the room warms.
What guarantee comes with a roof lantern?
Manufacturer guarantees apply to the frame, coating and sealed units, and the terms are confirmed in writing. The upstand and roof covering may be covered separately, depending on who builds them. Guarantee terms for the installation are set out in writing with your quote, so you know exactly what is covered before going ahead.
How long does it take to fit a roof lantern?
Fitting a roof lantern on a prepared upstand usually takes a day or less for a typical size, longer for large or complex shapes. The lantern is made to order first, and the lead time depends on its size, shape and colour. Building or rebuilding an upstand is separate roofing work that comes before fitting.
Should the inner glass in a roof lantern be laminated?
Laminated inner glass is the safer choice and is recommended by the Rooflight Association. If a laminated pane breaks, the interlayer holds the pieces together, so glass is far less likely to fall into the room below. This matters most over kitchens, dining tables, stairs and seating, and it is offered as a standard option.
Do you cover Esher for roof lanterns?
Yes. We can quote for roof lanterns across Esher and the surrounding Surrey area, including postcode districts KT7 and KT10, and nearby Walton-on-Thames, Hampton and Sunbury-on-Thames. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Esher
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.