Egham · Surrey
Secondary Glazing in Egham
We cover Egham and Surrey for secondary glazing in period homes, flats and listed buildings, with sightlines matched to the original windows.
- TW20
- Guide from £465
Secondary glazing for homes and businesses in Egham
Secondary glazing leaves the original window untouched and fits a second, independent window inside it. The air gap between the two works with the glass to reduce noise and heat loss. In most cases the installation can be taken out later without damaging the historic window or reveal.
Condensation in the gap between the two windows is reduced by making the secondary unit the more airtight of the two. The original window should not be fully sealed, so any moisture that gets into the cavity can escape outside rather than being trapped against the glass.
Glass for secondary glazing is heavy, so the frames need firm fixings into the reveal or a supporting sub-frame. The surveyor checks that plaster, timber linings and window boards are sound enough to carry the weight, and allows for any packing needed in uneven reveals.
Owners of listed buildings should seek listed building consent before installing secondary glazing, as the requirements depend on the building and the council. Secondary glazing is often seen as a minimal, reversible change, but carrying out works that need consent without it is a criminal offence.
What you get
- Made-to-measure slim aluminium frames and glass
- Removal of packaging and cleaning of new glass
- Written quote fixing the price for the specification
- Fitting, sealing and checking every opening panel
Local details for Egham
- Postcodes covered
- TW20 and the surrounding area, including Staines, Ashford (Surrey) and Windsor
- Coast
- Egham is well inland, around 64 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Egham the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Secondary glazing adds an extra layer of glass, which slightly reduces daylight. Low-iron or clear low-E glass keeps light loss to a minimum, while on sunny elevations solar control glass can help reduce overheating in rooms with large windows.
- Access and setting
- Rural cottages and period homes often have single-glazed timber windows that cannot easily be replaced. Secondary glazing reduces draughts and heat loss in exposed locations, and the surveyor allows for uneven reveals and older plaster when fixing frames.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Egham
| Typical job | Guide price inc VAT |
|---|---|
| Slider, 900 × 1200 mm | £465 – £595 |
| Slider, 1200 × 1600 mm | £665 – £845 |
| Acoustic glass, 1000 × 1400 mm | £675 – £865 |
Get a guide price for your size
Approved Document B covers escape windows. Where an existing window is an escape route, typically in first-floor bedrooms, its replacement should give at least the same escape opening as before.
What you can choose
Lift-out panel
A lightweight panel that lifts out of its frame, for windows rarely opened, giving a slim and economical secondary unit.
Hinged casement
Panels open inwards like a door, giving full access to the original window, and can be chosen for escape windows.
Acoustic laminated glass
Laminated glass with a sound-dampening interlayer, combined with a generous cavity, for properties affected by traffic, rail or aircraft noise.
Secondary Glazing in Egham: questions
Will secondary glazing cause condensation?
It can, if the original window is sealed tighter than the secondary unit, because warm, moist room air then gets trapped in the cavity. The secondary unit should be the more airtight of the two, and the original window should not be fully sealed. Opening the secondary panel lets room air into the cavity, so close it again afterwards.
How do I clean and look after secondary glazing?
Open or remove the panels as designed, then clean the glass with mild soapy water and a soft cloth. Wipe the aluminium frames and runners, and keep tracks free of dust so panels slide smoothly. Check seals and catches occasionally. Avoid abrasive cleaners, which can scratch coated glass.
Is secondary glazing as good as double glazing?
It depends on the goal. For noise, secondary glazing is often more effective, because the wider gap between the two windows reduces sound better than the narrow cavity of a sealed unit. For heat, a well-sealed secondary unit with low-E glass significantly improves a single-glazed window. It also keeps original windows, which matters in listed buildings.
Is secondary glazing suitable for rented homes and flats?
Yes. Secondary glazing is fitted inside, so it often avoids the external changes that leases, freeholders or planning rules restrict. It can be removed later with limited making good. Leaseholders should still check their lease for any rules on internal alterations, and landlords should check escape routes are not affected.
Do you cover Egham for secondary glazing?
Yes. We can quote for secondary glazing across Egham and the surrounding Surrey area, including postcode districts TW20, and nearby Staines, Ashford (Surrey) and Windsor. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Egham
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.