Dundee · Angus & Dundee
Shower Screens in Dundee
Shower screens in Dundee start with a survey once the tiling is finished, followed by a written quote that fixes the price for the glass, hardware and finish shown.
- DD1
- DD2
- DD3
- DD4
- DD5
- Guide from £395
Made to measure shower screen in Dundee: what to know
Because toughened glass cannot be cut or drilled after toughening, hinge holes, clamp positions and notches around trays or skirting are formed before the glass goes into the furnace. A panel that does not fit has to be remade, so accurate templating matters.
The glass screen stops spray, but it is not the waterproofing. The tanking behind the tiles, the tray or floor fall and the drain do that job. Clear silicone along the glass edges then seals the joints, and it needs time to cure before the shower is used.
Toughened glass can very occasionally break on its own because of nickel sulphide inclusions. Heat soak testing to BS EN 14179 reduces that risk by breaking flawed panels in the factory, though it cannot remove it completely, and it can be specified for any screen.
A walk-in panel fixed only at the wall and floor needs a bracing bar running to the wall or ceiling to stop it flexing. The bar's position is planned around tiles, windows and shower valves, and a floor channel can reduce or remove the need for a brace.
What you get
- Clear silicone sealing to tray, floor and walls
- Fixing into solid backing, levelled and aligned
- Made-to-measure toughened safety glass with factory-made holes
- Hinges, clamps, channels or bracing bars in your finish
Working in Dundee
- Postcodes covered
- DD1, DD2, DD3, DD4, DD5 and the surrounding area, including Carnoustie, St Andrews and Forfar
- Coast
- Dundee is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Shower glass sits indoors, so salt air has little effect on it, but coastal homes can have damp, humid air that slows drying. Good bathroom ventilation and a quick squeegee after use help prevent mould on the silicone and marks on the hardware.
- Daylight and sun
- In Dundee the midwinter sun reaches about 10° above the horizon at noon, with roughly 6.6 hours of daylight, rising to about 57° and 17.4 hours in midsummer. Bathrooms with small or north-facing windows benefit from clear or low-iron glass that does not block the daylight available. Where a window looks onto the shower, a satin band or obscure glass gives privacy without making the room feel darker.
- Access and setting
- Flats often mean carrying large panels up stairs or in small lifts, so panel sizes may need splitting. Building rules on working hours and noise, and bathrooms above other homes, make careful sealing and protection of finishes especially important.
- Rules in Scotland
- Section 4 (Safety) of the Scottish Technical Handbooks covers glazing that people could collide with, such as glass in and beside doors and low-level glazing, where safety glass is needed.
Guide prices in Dundee
| Typical job | Guide price inc VAT |
|---|---|
| Walk-in shower panel | £395 – £695 |
| Hinged door with in-line panel | £795 – £1,295 |
| Corner or full enclosure | £995 – £1,595 |
Choosing your shower screens
Over-bath screen
A fixed or hinged toughened glass panel on the bath edge, made to measure for baths that sit against sloping ceilings or uneven walls.
Easy-clean coating
A water-repellent coating bonded to the glass that helps water bead and run off, reducing limescale and the time spent cleaning.
Pivot door
A door that swings on pivots set in from its edge, useful where the swing space in front of the shower is limited.
Shower Screens in Dundee: questions
When should my shower screen be measured?
Your screen should be measured once the walls are tiled and the tray or wet room floor is finished. The glass is made to follow the exact angles of the finished surfaces, and tiles, adhesive and trims all change the dimensions. If you are mid-renovation, we can advise on fixing positions and backing before tiling starts.
What thickness of glass should a shower screen be?
For frameless screens, 8mm toughened glass suits most doors and enclosures, and 10mm is commonly used for walk-in and wet room panels that stand with little support. Thinner glass is used in framed enclosures where the frame does some of the work. We recommend a thickness at survey based on the panel size and how it is fixed.
How long does it take to fit a shower screen?
Most shower screens are fitted in a single visit once the glass has been made, which usually takes a couple of weeks after measuring. The silicone then needs time to cure, so you should wait before using the shower, and we tell you how long on the day. Your quote confirms the expected timescale.
Can a shower screen be fitted to a stud or plasterboard wall?
Yes, provided the hinges and brackets fix into solid backing. On stud or plasterboard walls that usually means timber noggins behind the fixing points, or suitable heavy-duty fixings where noggins were not fitted. A heavy glass door on weak fixings can drop or pull away, so we check the wall during the survey.
Do you cover Dundee for shower screens?
Yes. We can quote for shower screens across Dundee and the surrounding Angus & Dundee area, including postcode districts DD1, DD2, DD3, DD4 and DD5, and nearby Carnoustie, St Andrews and Forfar. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Dundee
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.