Chelsea · Greater London
Shower Screens in Chelsea
Awkward alcoves and sloping ceilings in Chelsea bathrooms are where made-to-measure shower glass helps, because each panel is cut to the real shape before it is toughened.
- SW3
- SW10
- SW7
- Guide from £395
Wet room glass panel in Chelsea: what to know
Because toughened glass cannot be cut or drilled after toughening, hinge holes, clamp positions and notches around trays or skirting are formed before the glass goes into the furnace. A panel that does not fit has to be remade, so accurate templating matters.
A walk-in panel fixed only at the wall and floor needs a bracing bar running to the wall or ceiling to stop it flexing. The bar's position is planned around tiles, windows and shower valves, and a floor channel can reduce or remove the need for a brace.
Glass-to-wall and glass-to-glass hinges suit most doors, and pivot hinges let a door swing from a point set in from the edge. Doors normally open outwards, so check the swing clears the toilet, basin and bathroom door before choosing a layout.
The glass screen stops spray, but it is not the waterproofing. The tanking behind the tiles, the tray or floor fall and the drain do that job. Clear silicone along the glass edges then seals the joints, and it needs time to cure before the shower is used.
What you get
- Survey and measurement once tiling is complete
- Made-to-measure toughened safety glass with factory-made holes
- Easy-clean coating where specified, plus care advice
- Hinges, clamps, channels or bracing bars in your finish
About Chelsea for this job
- Postcodes covered
- SW3, SW10, SW7 and the surrounding area, including Fulham, Kensington and Clapham
- Coast
- Chelsea is well inland, around 37 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Chelsea the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Bathrooms with small or north-facing windows benefit from clear or low-iron glass that does not block the daylight available. Where a window looks onto the shower, a satin band or obscure glass gives privacy without making the room feel darker.
- Access and setting
- Older rural homes often have uneven walls, sloping ceilings and timber floors that flex, all of which shape the screen design. Hard water is common in some areas, so an easy-clean coating and regular squeegeeing help keep the glass clear.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Chelsea
| Typical job | Guide price inc VAT |
|---|---|
| Walk-in shower panel | £395 – £695 |
| Hinged door with in-line panel | £795 – £1,295 |
| Corner or full enclosure | £995 – £1,595 |
What you can choose
Over-bath screen
A fixed or hinged toughened glass panel on the bath edge, made to measure for baths that sit against sloping ceilings or uneven walls.
Low-iron glass
Glass with less iron, which removes the green edge tint of standard glass and keeps tiles and stone looking their true colour.
Walk-in wet room panel
A single fixed glass panel with a bracing bar or floor channel, leaving an open entry and no door to clean or adjust.
Shower Screens in Chelsea: questions
How do I stop limescale building up on shower glass?
The simplest habit is to squeegee the glass after every shower so water does not dry on it. Clean weekly with a mild, non-abrasive bathroom cleaner and a soft cloth, and rinse well. Avoid scouring pads, powders and strong descalers, which can scratch coatings, dull hinge finishes and break down silicone seals.
How long does it take to fit a shower screen?
Most shower screens are fitted in a single visit once the glass has been made, which usually takes a couple of weeks after measuring. The silicone then needs time to cure, so you should wait before using the shower, and we tell you how long on the day. Your quote confirms the expected timescale.
Is a chipped shower screen safe to keep using?
A chip on the edge of toughened glass can weaken the whole panel, because the surface is under stress and damage at the edge can lead to sudden breakage. It is safer to stop using that door or panel and have it replaced. We can remake it from the original measurements or a fresh template.
What thickness of glass should a shower screen be?
For frameless screens, 8mm toughened glass suits most doors and enclosures, and 10mm is commonly used for walk-in and wet room panels that stand with little support. Thinner glass is used in framed enclosures where the frame does some of the work. We recommend a thickness at survey based on the panel size and how it is fixed.
Do you cover Chelsea for shower screens?
Yes. We can quote for shower screens across Chelsea and the surrounding Greater London area, including postcode districts SW3, SW10 and SW7, and nearby Fulham, Kensington and Clapham. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Chelsea
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.