Sutton · Greater London
Shower Screens in Sutton
Is a chipped or sagging shower door bothering you in Sutton? We can measure, remake and refit the glass, and check the hinges and wall fixings at the same time.
- KT4
- SM1
- SM2
- SM3
- SM5
- SM6
- Guide from £395
Sutton: walk in shower screen
A walk-in panel fixed only at the wall and floor needs a bracing bar running to the wall or ceiling to stop it flexing. The bar's position is planned around tiles, windows and shower valves, and a floor channel can reduce or remove the need for a brace.
The glass screen stops spray, but it is not the waterproofing. The tanking behind the tiles, the tray or floor fall and the drain do that job. Clear silicone along the glass edges then seals the joints, and it needs time to cure before the shower is used.
Because toughened glass cannot be cut or drilled after toughening, hinge holes, clamp positions and notches around trays or skirting are formed before the glass goes into the furnace. A panel that does not fit has to be remade, so accurate templating matters.
Glass thickness is usually 8mm or 10mm for frameless work. 8mm suits most doors and enclosures, while 10mm is commonly used for walk-in and wet room panels that stand with little support and need to stay rigid when knocked or leaned on.
What's included
- Easy-clean coating where specified, plus care advice
- Hinges, clamps, channels or bracing bars in your finish
- Survey and measurement once tiling is complete
- Clear silicone sealing to tray, floor and walls
Working in Sutton
- Postcodes covered
- KT4, SM1, SM2, SM3, SM5, SM6 and the surrounding area, including Carshalton, Banstead and Ewell
- Coast
- Sutton is well inland, around 41 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Sutton the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Bathrooms with small or north-facing windows benefit from clear or low-iron glass that does not block the daylight available. Where a window looks onto the shower, a satin band or obscure glass gives privacy without making the room feel darker.
- Access and setting
- Flats often mean carrying large panels up stairs or in small lifts, so panel sizes may need splitting. Building rules on working hours and noise, and bathrooms above other homes, make careful sealing and protection of finishes especially important.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Sutton
| Typical job | Guide price inc VAT |
|---|---|
| Walk-in shower panel | £395 – £695 |
| Hinged door with in-line panel | £795 – £1,295 |
| Corner or full enclosure | £995 – £1,595 |
What you can choose
Walk-in wet room panel
A single fixed glass panel with a bracing bar or floor channel, leaving an open entry and no door to clean or adjust.
Over-bath screen
A fixed or hinged toughened glass panel on the bath edge, made to measure for baths that sit against sloping ceilings or uneven walls.
Low-iron glass
Glass with less iron, which removes the green edge tint of standard glass and keeps tiles and stone looking their true colour.
Shower Screens in Sutton: questions
How do I stop limescale building up on shower glass?
The simplest habit is to squeegee the glass after every shower so water does not dry on it. Clean weekly with a mild, non-abrasive bathroom cleaner and a soft cloth, and rinse well. Avoid scouring pads, powders and strong descalers, which can scratch coatings, dull hinge finishes and break down silicone seals.
When should my shower screen be measured?
Your screen should be measured once the walls are tiled and the tray or wet room floor is finished. The glass is made to follow the exact angles of the finished surfaces, and tiles, adhesive and trims all change the dimensions. If you are mid-renovation, we can advise on fixing positions and backing before tiling starts.
What thickness of glass should a shower screen be?
For frameless screens, 8mm toughened glass suits most doors and enclosures, and 10mm is commonly used for walk-in and wet room panels that stand with little support. Thinner glass is used in framed enclosures where the frame does some of the work. We recommend a thickness at survey based on the panel size and how it is fixed.
How long does it take to fit a shower screen?
Most shower screens are fitted in a single visit once the glass has been made, which usually takes a couple of weeks after measuring. The silicone then needs time to cure, so you should wait before using the shower, and we tell you how long on the day. Your quote confirms the expected timescale.
Do you cover Sutton for shower screens?
Yes. We can quote for shower screens across Sutton and the surrounding Greater London area, including postcode districts KT4, SM1, SM2, SM3 and SM5, and nearby Carshalton, Banstead and Ewell. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Sutton
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.