Folkestone · Kent
Shower Screens in Folkestone
We cover Folkestone and Kent for made-to-measure shower screens, from walk-in wet room panels to hinged corner enclosures, with every job surveyed and quoted in writing.
- CT19
- CT20
- Guide from £395
Bespoke shower enclosure for homes and businesses in Folkestone
Toughened glass can very occasionally break on its own because of nickel sulphide inclusions. Heat soak testing to BS EN 14179 reduces that risk by breaking flawed panels in the factory, though it cannot remove it completely, and it can be specified for any screen.
An easy-clean coating is a water-repellent layer bonded to the glass that helps water run off and reduces limescale and soap marks. It does not stop cleaning altogether, and how long it lasts depends on following the care instructions and avoiding abrasive products.
A walk-in panel fixed only at the wall and floor needs a bracing bar running to the wall or ceiling to stop it flexing. The bar's position is planned around tiles, windows and shower valves, and a floor channel can reduce or remove the need for a brace.
The price depends mainly on panel sizes, the number of panels, glass thickness, the hinge and bracing hardware, and any cut-outs for sloping ceilings, trays or skirting. Low-iron or satin glass, an easy-clean coating and special finishes add cost. See the guide prices for typical ranges.
Included as standard
- Easy-clean coating where specified, plus care advice
- Hinges, clamps, channels or bracing bars in your finish
- Made-to-measure toughened safety glass with factory-made holes
- Fixing into solid backing, levelled and aligned
Local details for Folkestone
- Postcodes covered
- CT19, CT20 and the surrounding area, including Dover, Ashford (Kent) and Deal
- Coast
- Folkestone is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Shower glass sits indoors, so salt air has little effect on it, but coastal homes can have damp, humid air that slows drying. Good bathroom ventilation and a quick squeegee after use help prevent mould on the silicone and marks on the hardware.
- Daylight and sun
- In Folkestone the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 62° and 16.3 hours in midsummer. Bathrooms with small or north-facing windows benefit from clear or low-iron glass that does not block the daylight available. Where a window looks onto the shower, a satin band or obscure glass gives privacy without making the room feel darker.
- Access and setting
- Flats often mean carrying large panels up stairs or in small lifts, so panel sizes may need splitting. Building rules on working hours and noise, and bathrooms above other homes, make careful sealing and protection of finishes especially important.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Folkestone
| Typical job | Guide price inc VAT |
|---|---|
| Walk-in shower panel | £395 – £695 |
| Hinged door with in-line panel | £795 – £1,295 |
| Corner or full enclosure | £995 – £1,595 |
Specification choices
Easy-clean coating
A water-repellent coating bonded to the glass that helps water bead and run off, reducing limescale and the time spent cleaning.
Over-bath screen
A fixed or hinged toughened glass panel on the bath edge, made to measure for baths that sit against sloping ceilings or uneven walls.
Walk-in wet room panel
A single fixed glass panel with a bracing bar or floor channel, leaving an open entry and no door to clean or adjust.
Shower Screens in Folkestone: questions
Is a chipped shower screen safe to keep using?
A chip on the edge of toughened glass can weaken the whole panel, because the surface is under stress and damage at the edge can lead to sudden breakage. It is safer to stop using that door or panel and have it replaced. We can remake it from the original measurements or a fresh template.
What thickness of glass should a shower screen be?
For frameless screens, 8mm toughened glass suits most doors and enclosures, and 10mm is commonly used for walk-in and wet room panels that stand with little support. Thinner glass is used in framed enclosures where the frame does some of the work. We recommend a thickness at survey based on the panel size and how it is fixed.
When should my shower screen be measured?
Your screen should be measured once the walls are tiled and the tray or wet room floor is finished. The glass is made to follow the exact angles of the finished surfaces, and tiles, adhesive and trims all change the dimensions. If you are mid-renovation, we can advise on fixing positions and backing before tiling starts.
How long does it take to fit a shower screen?
Most shower screens are fitted in a single visit once the glass has been made, which usually takes a couple of weeks after measuring. The silicone then needs time to cure, so you should wait before using the shower, and we tell you how long on the day. Your quote confirms the expected timescale.
Do you cover Folkestone for shower screens?
Yes. We can quote for shower screens across Folkestone and the surrounding Kent area, including postcode districts CT19 and CT20, and nearby Dover, Ashford (Kent) and Deal. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Folkestone
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.