Kenilworth · Warwickshire
Shower Screens in Kenilworth
Shower screens in Kenilworth start with a survey once the tiling is finished, followed by a written quote that fixes the price for the glass, hardware and finish shown.
- CV8
- Guide from £395
About bespoke shower enclosure in Kenilworth
The glass screen stops spray, but it is not the waterproofing. The tanking behind the tiles, the tray or floor fall and the drain do that job. Clear silicone along the glass edges then seals the joints, and it needs time to cure before the shower is used.
The price depends mainly on panel sizes, the number of panels, glass thickness, the hinge and bracing hardware, and any cut-outs for sloping ceilings, trays or skirting. Low-iron or satin glass, an easy-clean coating and special finishes add cost. See the guide prices for typical ranges.
Glass-to-wall and glass-to-glass hinges suit most doors, and pivot hinges let a door swing from a point set in from the edge. Doors normally open outwards, so check the swing clears the toilet, basin and bathroom door before choosing a layout.
Screens should be measured after tiling is finished, not from plans. Walls are often out of plumb and floors fall towards the drain, and the glass is made to follow those real angles. Measuring early is a common cause of uneven gaps and leaks.
Included as standard
- Hinges, clamps, channels or bracing bars in your finish
- Fixing into solid backing, levelled and aligned
- Clear silicone sealing to tray, floor and walls
- Survey and measurement once tiling is complete
Kenilworth at a glance
- Postcodes covered
- CV8 and the surrounding area, including Warwick, Coventry and Leamington Spa
- Coast
- Kenilworth is well inland, around 84 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Kenilworth the midwinter sun reaches about 14° above the horizon at noon, with roughly 7.4 hours of daylight, rising to about 61° and 16.6 hours in midsummer. Bathrooms with small or north-facing windows benefit from clear or low-iron glass that does not block the daylight available. Where a window looks onto the shower, a satin band or obscure glass gives privacy without making the room feel darker.
- Access and setting
- Older rural homes often have uneven walls, sloping ceilings and timber floors that flex, all of which shape the screen design. Hard water is common in some areas, so an easy-clean coating and regular squeegeeing help keep the glass clear.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Kenilworth
| Typical job | Guide price inc VAT |
|---|---|
| Walk-in shower panel | £395 – £695 |
| Hinged door with in-line panel | £795 – £1,295 |
| Corner or full enclosure | £995 – £1,595 |
Choosing your shower screens
Over-bath screen
A fixed or hinged toughened glass panel on the bath edge, made to measure for baths that sit against sloping ceilings or uneven walls.
Walk-in wet room panel
A single fixed glass panel with a bracing bar or floor channel, leaving an open entry and no door to clean or adjust.
Easy-clean coating
A water-repellent coating bonded to the glass that helps water bead and run off, reducing limescale and the time spent cleaning.
Shower Screens in Kenilworth: questions
Why have a shower screen made to measure instead of buying one?
A made-to-measure screen fits the space exactly, which matters where walls are out of plumb, ceilings slope, trays are non-standard or the opening is an unusual width. Off-the-shelf enclosures rely on adjustment profiles that can leave wide gaps or visible frames. Bespoke glass follows the real shape of the room and keeps sealant lines neat.
Is a chipped shower screen safe to keep using?
A chip on the edge of toughened glass can weaken the whole panel, because the surface is under stress and damage at the edge can lead to sudden breakage. It is safer to stop using that door or panel and have it replaced. We can remake it from the original measurements or a fresh template.
How do I stop limescale building up on shower glass?
The simplest habit is to squeegee the glass after every shower so water does not dry on it. Clean weekly with a mild, non-abrasive bathroom cleaner and a soft cloth, and rinse well. Avoid scouring pads, powders and strong descalers, which can scratch coatings, dull hinge finishes and break down silicone seals.
Can a shower screen be fitted to a stud or plasterboard wall?
Yes, provided the hinges and brackets fix into solid backing. On stud or plasterboard walls that usually means timber noggins behind the fixing points, or suitable heavy-duty fixings where noggins were not fitted. A heavy glass door on weak fixings can drop or pull away, so we check the wall during the survey.
Do you cover Kenilworth for shower screens?
Yes. We can quote for shower screens across Kenilworth and the surrounding Warwickshire area, including postcode districts CV8, and nearby Warwick, Coventry and Leamington Spa. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Kenilworth
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.