Caterham · Surrey
Safety Glass in Caterham
Need a glass panel made to measure in Caterham? Our glaziers confirm the thickness, edge finish and holes before the glass is toughened.
- CR3
- CR6
- RH9
- Guide from £55
Toughened glass panels for homes and businesses in Caterham
Laminated glass is two or more sheets bonded with a plastic interlayer, often PVB. If it breaks, the pieces stick to the interlayer and the pane stays in place. That makes it useful for overhead glass, ground-floor security and openings where an empty hole would be a risk.
In England, Approved Document K requires safety glass in critical locations: glass in a door or within 300mm of a door edge, up to 1500mm above the floor, and other glass within 800mm of the floor. The rules are similar elsewhere in the UK, but the detail differs.
Edge finish affects both look and safety. Arrised edges are lightly sanded to take off sharpness and suit glass held in frames. Polished edges are smooth and clear for exposed edges on tables, shelves and frameless panels. Bevelled edges add a decorative angled border.
Glass tabletops and shelves need the right thickness for the span and load. Thicker glass deflects less, so a long shelf or a large table needs a heavier panel than a small side table. The supplier confirms a suitable thickness for the use, not just the size.
What you get
- Written quote fixing the price for the specification
- Permanent safety marking on building glass
- Measurement or templating of the glass panel
- Glass cut, edge-worked and drilled before toughening
About Caterham for this job
- Postcodes covered
- CR3, CR6, RH9 and the surrounding area, including Coulsdon, Purley and Redhill
- Coast
- Caterham is well inland, around 36 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Caterham the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Strong sun on large glass panels can cause glare and fade furniture behind them. Tinted, solar control or low-iron toughened glass each change how much light, heat and colour come through, so orientation is worth considering when choosing.
- Access and setting
- Older rural homes often have internal doors and screens with old, unmarked glass. Upgrading them to toughened or laminated safety glass is common, and timber door frames may need careful beading when the new glass is fitted.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Caterham
| Typical job | Guide price inc VAT |
|---|---|
| 6 mm toughened panel, 800 × 600 mm | £55 – £75 |
| 10 mm toughened panel, 1000 × 2000 mm | £325 – £415 |
| Glass tabletop or shelf, 1200 × 600 mm, 8 mm | £135 – £165 |
| 6.4 mm laminated panel, 900 × 900 mm | £115 – £145 |
Get a guide price for your size
Approved Document Q applies to new homes in England, where doors and windows are expected to meet PAS 24 or an equivalent standard. It does not apply to replacements in existing homes, but PAS 24 products are still a sensible choice.
Choosing your safety glass
Heat soak testing
An extra heat test after toughening that reduces the risk of spontaneous breakage from nickel sulphide inclusions in the glass.
Laminated safety glass
Two or more sheets bonded with an interlayer that holds broken glass in place, for overhead, security and fall-risk locations.
Clear toughened glass
Heat-treated float glass that breaks into small, blunt pieces, for doors, screens, tabletops and shelves in a range of thicknesses.
Safety Glass in Caterham: questions
Can toughened glass break on its own?
Rarely, yes. Tiny nickel sulphide inclusions in the glass can expand over time and cause a toughened pane to break without an obvious impact. Edge damage during fitting can also cause later failure. Heat soak testing reduces the risk of inclusion-related breakage, and careful handling and correct fitting protect the edges.
Where is safety glass required in a house?
In England, safety glass is needed in critical locations: glass in doors and within 300mm of a door edge, up to 1500mm above floor level, and other glass within 800mm of the floor. Small panes and leaded lights have specific exceptions. The rules elsewhere in the UK are similar, but the detail differs between nations.
What thickness of toughened glass do I need for a table or shelf?
It depends on the size, how the glass is supported and the load it will carry. Small side tables can use thinner glass, while large dining tables and long shelves need thicker panels to limit bending. Tell us the dimensions, support method and what it will hold, and we will confirm a suitable thickness in the quote.
Is laminated glass better for security?
Laminated glass usually gives better security than toughened glass of similar thickness, because the interlayer holds the glass together after it cracks, so making a hole takes more effort. Thicker interlayers and multi-layer laminates give more resistance. For ground-floor windows, shopfronts and doors, laminated glass is often chosen for this reason.
Do you cover Caterham for safety glass?
Yes. We can quote for safety glass across Caterham and the surrounding Surrey area, including postcode districts CR3, CR6 and RH9, and nearby Coulsdon, Purley and Redhill. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Caterham
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.