Comber · County Down
Curtain Walling in Comber
Misted, cracked or leaking facade units in Comber can usually be replaced individually, and we can survey the system and access before quoting.
- BT23
- BT16
- Guide from £455 per m²
Curtain wall glass replacement for homes and businesses in Comber
A stick system is built on site piece by piece. Aluminium mullions and transoms are fixed to the structure first, then the glass and infill panels go in, and finally the pressure plates and caps. It suits low-rise buildings and screens but needs access to both faces.
BS EN 13830 is the product standard for curtain walling. It treats the system as a kit, including its fixings, set from vertical up to 15 degrees off vertical. Sloping roof glazing and patent glazing fall outside it and are covered by other standards.
Curtain walling needs planned upkeep. Clean frames and glass regularly, keep drainage outlets clear, and inspect gaskets, seals and fixings for shrinkage, gaps or corrosion. Failed or misted sealed units can usually be replaced individually without removing the surrounding framing.
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
Included as standard
- Fabrication drawings and coordination with other trades
- Final inspection, clean and maintenance guidance
- Supply and installation of framing, glass and panels
- Survey of openings, supporting structure and access
Comber at a glance
- Postcodes covered
- BT23, BT16 and the surrounding area, including Newtownards, Dundonald and Castlereagh
- Coast
- Comber sits roughly 13 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Facades near the sea face salt-laden wind and driving rain, which attack frame finishes and stress seals. Suitable coating specifications, regular washing, gasket checks and higher design wind loads for exposed sites all matter for curtain walling there.
- Daylight and sun
- In Comber the midwinter sun reaches about 12° above the horizon at noon, with roughly 7.0 hours of daylight, rising to about 59° and 17.0 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in Northern Ireland
- Technical Booklet V covers safety glazing in Northern Ireland, including glass in and around doors and low-level glazing where people could walk into it.
Guide prices in Comber
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Replacement windows on houses in Northern Ireland are often permitted development, but conservation areas and listed buildings can need consent. Check with the council's planning office.
Options to choose between
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Opaque spandrel panels
Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.
Curtain Walling in Comber: questions
What affects the cost of curtain walling?
The main cost drivers are facade area, system type, glass specification, infill panels, opening vents, building height and access equipment such as scaffolding, hoists or cranes. Structural silicone glazing, unitised panels, fire-resisting sections and testing requirements add cost. See the guide prices for typical ranges, and your written quote fixes the price for the specification.
What is the difference between curtain walling and windows?
Curtain walling is a continuous framed wall of glass and panels that spans across floors and hangs off the building structure, carrying its own weight and wind loads. Windows sit within individual openings in a masonry or framed wall. Curtain walling suits large glazed areas and multi-storey facades, while windows suit punched openings.
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
How long does a curtain walling project take?
Timescales depend on size and complexity. Design, approvals and fabrication of framing and glass usually take several weeks to a few months before installation starts. Installation then depends on the facade area, access and sequencing with other trades. Replacing individual units is much quicker once the glass is made. Your written quote sets out the expected programme.
Do you cover Comber for curtain walling?
Yes. We can quote for curtain walling across Comber and the surrounding County Down area, including postcode districts BT23 and BT16, and nearby Newtownards, Dundonald and Castlereagh. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Comber
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.