Doncaster · South Yorkshire
Curtain Walling in Doncaster
We cover Doncaster and South Yorkshire for curtain walling and glazed screens, from new commercial facades to replacing failed glass units in existing buildings.
- DN1
- DN4
- DN2
- Guide from £455 per m²
Doncaster: curtain wall glass replacement
Where a glazed screen must resist fire, the glass only performs as part of a fire-resistant system tested with its frame, seals, beads and fixings. Ratings use letters such as E for integrity and EI for integrity and insulation, and components must not be swapped without test evidence.
Wind load on a facade rises with height, exposure and building shape, and it decides the mullion size, bracket design and glass thickness. Calculations for the specific site are part of the design, so a system suited to a sheltered ground-floor screen may not suit an exposed upper storey.
BS EN 13830 is the product standard for curtain walling. It treats the system as a kit, including its fixings, set from vertical up to 15 degrees off vertical. Sloping roof glazing and patent glazing fall outside it and are covered by other standards.
The Centre for Window and Cladding Technology publishes the Standard for systemised building envelopes, the recognised UK industry standard for specifying, testing and assessing curtain walling. It draws in BS EN 13830 and the relevant building regulations, and is often referenced in commercial specifications.
Included as standard
- Final inspection, clean and maintenance guidance
- System selection and glass specification for the building
- Supply and installation of framing, glass and panels
- Fabrication drawings and coordination with other trades
Doncaster at a glance
- Postcodes covered
- DN1, DN4, DN2 and the surrounding area, including Dinnington, Rotherham and Pontefract
- Coast
- Doncaster is well inland, around 35 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Doncaster the midwinter sun reaches about 13° above the horizon at noon, with roughly 7.2 hours of daylight, rising to about 60° and 16.8 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Doncaster
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Curtain Walling in Doncaster: questions
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
Can a single broken glass unit in a curtain wall be replaced?
Usually, yes. In capped systems the cap and pressure plate are removed to release the glass, and a new unit is fitted and resealed. Structurally bonded glass needs the new unit bonding to its carrier, which takes more preparation. Height and access drive much of the work, so we survey the unit and access before quoting.
What is the difference between curtain walling and windows?
Curtain walling is a continuous framed wall of glass and panels that spans across floors and hangs off the building structure, carrying its own weight and wind loads. Windows sit within individual openings in a masonry or framed wall. Curtain walling suits large glazed areas and multi-storey facades, while windows suit punched openings.
Do you cover Doncaster for curtain walling?
Yes. We can quote for curtain walling across Doncaster and the surrounding South Yorkshire area, including postcode districts DN1, DN4 and DN2, and nearby Dinnington, Rotherham and Pontefract. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Doncaster
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.