Newcastle-under-Lyme · Staffordshire
Curtain Walling in Newcastle-under-Lyme
Is water getting in around an older glazed facade in Newcastle-under-Lyme? We can inspect gaskets, seals and drainage paths and quote for the repairs or replacement needed.
- ST5
- Guide from £455 per m²
Glazed facade systems across Newcastle-under-Lyme
Toughened glass can very occasionally break on its own because of nickel sulphide inclusions. Heat soak testing to BS EN 14179 reduces that risk by breaking flawed panes in the factory, and it is often specified for toughened glass high on facades where a breakage is harder to deal with.
Under the energy rules for new work in England, curtain walling performance is assessed for the whole system, including frames and opaque infill panels, not just the glass. Solar gain through the glass is also considered, so the glass choice balances heat loss, overheating and daylight.
Building regulations require external walls to limit the spread of fire, so curtain walling design has to consider how its materials react to fire and how fire could pass between floors. The requirements depend on the building's height and use, and differ between the UK nations.
A stick system is built on site piece by piece. Aluminium mullions and transoms are fixed to the structure first, then the glass and infill panels go in, and finally the pressure plates and caps. It suits low-rise buildings and screens but needs access to both faces.
What you get
- Sealing, weathering and drainage details at all interfaces
- System selection and glass specification for the building
- Survey of openings, supporting structure and access
- Supply and installation of framing, glass and panels
About Newcastle-under-Lyme for this job
- Postcodes covered
- ST5 and the surrounding area, including Stoke-on-Trent, Longton and Kidsgrove
- Coast
- Newcastle-under-Lyme is well inland, around 50 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Newcastle-under-Lyme the midwinter sun reaches about 14° above the horizon at noon, with roughly 7.3 hours of daylight, rising to about 60° and 16.7 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Newcastle-under-Lyme
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
What you can choose
Integrated opening vents
Top-hung or parallel-opening vents built into the curtain wall grid to provide natural ventilation without breaking the facade line.
Stick curtain wall
Mullions and transoms assembled on site with glass and panels fitted afterwards, suited to low-rise buildings, entrances and ground-floor screens.
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Curtain Walling in Newcastle-under-Lyme: questions
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
How long does a curtain walling project take?
Timescales depend on size and complexity. Design, approvals and fabrication of framing and glass usually take several weeks to a few months before installation starts. Installation then depends on the facade area, access and sequencing with other trades. Replacing individual units is much quicker once the glass is made. Your written quote sets out the expected programme.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
Do you cover Newcastle-under-Lyme for curtain walling?
Yes. We can quote for curtain walling across Newcastle-under-Lyme and the surrounding Staffordshire area, including postcode districts ST5, and nearby Stoke-on-Trent, Longton and Kidsgrove. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Newcastle-under-Lyme
Get a written quote in Newcastle-under-Lyme
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.