Sunbury-on-Thames · Surrey
Curtain Walling in Sunbury-on-Thames
Planning a glazed facade in Sunbury-on-Thames? Our glaziers can survey the building and quote for stick or unitised curtain walling specified for its height, exposure and energy needs.
- TW16
- TW17
- KT12
- Guide from £455 per m²
About curtain walling in Sunbury-on-Thames
BS EN 13830 is the product standard for curtain walling. It treats the system as a kit, including its fixings, set from vertical up to 15 degrees off vertical. Sloping roof glazing and patent glazing fall outside it and are covered by other standards.
Toughened glass can very occasionally break on its own because of nickel sulphide inclusions. Heat soak testing to BS EN 14179 reduces that risk by breaking flawed panes in the factory, and it is often specified for toughened glass high on facades where a breakage is harder to deal with.
Under the energy rules for new work in England, curtain walling performance is assessed for the whole system, including frames and opaque infill panels, not just the glass. Solar gain through the glass is also considered, so the glass choice balances heat loss, overheating and daylight.
Where a glazed screen must resist fire, the glass only performs as part of a fire-resistant system tested with its frame, seals, beads and fixings. Ratings use letters such as E for integrity and EI for integrity and insulation, and components must not be swapped without test evidence.
What a typical job includes
- Final inspection, clean and maintenance guidance
- Survey of openings, supporting structure and access
- Fabrication drawings and coordination with other trades
- System selection and glass specification for the building
Sunbury-on-Thames at a glance
- Postcodes covered
- TW16, TW17, KT12 and the surrounding area, including Walton-on-Thames, Hampton and Hanworth
- Coast
- Sunbury-on-Thames is well inland, around 55 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Sunbury-on-Thames the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Sunbury-on-Thames
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
What you can choose
Stick curtain wall
Mullions and transoms assembled on site with glass and panels fitted afterwards, suited to low-rise buildings, entrances and ground-floor screens.
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Opaque spandrel panels
Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.
Curtain Walling in Sunbury-on-Thames: questions
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
How long does a curtain walling project take?
Timescales depend on size and complexity. Design, approvals and fabrication of framing and glass usually take several weeks to a few months before installation starts. Installation then depends on the facade area, access and sequencing with other trades. Replacing individual units is much quicker once the glass is made. Your written quote sets out the expected programme.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
Do glazed screens in offices and entrances need markings?
Large areas of clear glass that people could walk into need to be made visible. In England, the guidance for buildings other than dwellings puts manifestation at 850–1000mm and 1400–1600mm above the floor, and workplace rules across Great Britain require glass to be marked where needed for safety. Frosted bands or logos can meet this.
Do you cover Sunbury-on-Thames for curtain walling?
Yes. We can quote for curtain walling across Sunbury-on-Thames and the surrounding Surrey area, including postcode districts TW16, TW17 and KT12, and nearby Walton-on-Thames, Hampton and Hanworth. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Sunbury-on-Thames
Get a written quote in Sunbury-on-Thames
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.