Walton-on-Thames · Surrey
Curtain Walling in Walton-on-Thames
Is water getting in around an older glazed facade in Walton-on-Thames? We can inspect gaskets, seals and drainage paths and quote for the repairs or replacement needed.
- KT12
- TW17
- TW16
- Guide from £455 per m²
Commercial glazed screens for homes and businesses in Walton-on-Thames
The Centre for Window and Cladding Technology publishes the Standard for systemised building envelopes, the recognised UK industry standard for specifying, testing and assessing curtain walling. It draws in BS EN 13830 and the relevant building regulations, and is often referenced in commercial specifications.
Building regulations require external walls to limit the spread of fire, so curtain walling design has to consider how its materials react to fire and how fire could pass between floors. The requirements depend on the building's height and use, and differ between the UK nations.
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
Under the energy rules for new work in England, curtain walling performance is assessed for the whole system, including frames and opaque infill panels, not just the glass. Solar gain through the glass is also considered, so the glass choice balances heat loss, overheating and daylight.
Included as standard
- Fabrication drawings and coordination with other trades
- System selection and glass specification for the building
- Supply and installation of framing, glass and panels
- Sealing, weathering and drainage details at all interfaces
Local details for Walton-on-Thames
- Postcodes covered
- KT12, TW17, TW16 and the surrounding area, including Sunbury-on-Thames, Esher and Hampton
- Coast
- Walton-on-Thames is well inland, around 55 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Walton-on-Thames the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Walton-on-Thames
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Replacing windows and doors with similar ones is usually permitted development for houses in England. Flats, listed buildings and homes in conservation areas or covered by an Article 4 direction can need permission, so check with the council first.
What you can choose
Capped system
Glass clamped by pressure plates behind a visible external cap, available in different profiles and colours to emphasise the grid.
Integrated opening vents
Top-hung or parallel-opening vents built into the curtain wall grid to provide natural ventilation without breaking the facade line.
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Curtain Walling in Walton-on-Thames: questions
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
Can a single broken glass unit in a curtain wall be replaced?
Usually, yes. In capped systems the cap and pressure plate are removed to release the glass, and a new unit is fitted and resealed. Structurally bonded glass needs the new unit bonding to its carrier, which takes more preparation. Height and access drive much of the work, so we survey the unit and access before quoting.
Does new curtain walling need building regulations approval?
New curtain walling is building work that has to meet requirements for structure, energy and fire, so it is normally checked by building control as part of the project. The approval route depends on the building and the nation, because England, Wales, Scotland and Northern Ireland have separate systems. Planning permission may also be needed for changes to appearance.
Do you cover Walton-on-Thames for curtain walling?
Yes. We can quote for curtain walling across Walton-on-Thames and the surrounding Surrey area, including postcode districts KT12, TW17 and TW16, and nearby Sunbury-on-Thames, Esher and Hampton. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Walton-on-Thames
Get a written quote in Walton-on-Thames
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.