Ossett · West Yorkshire
Curtain Walling in Ossett
Our glaziers install aluminium curtain walling and full-height glazed screens in Ossett, coordinating with other trades and sealing every interface with the structure.
- WF5
- WF12
- WF13
- Guide from £455 per m²
Commercial glazed screens in Ossett
A stick system is built on site piece by piece. Aluminium mullions and transoms are fixed to the structure first, then the glass and infill panels go in, and finally the pressure plates and caps. It suits low-rise buildings and screens but needs access to both faces.
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
Toughened glass can very occasionally break on its own because of nickel sulphide inclusions. Heat soak testing to BS EN 14179 reduces that risk by breaking flawed panes in the factory, and it is often specified for toughened glass high on facades where a breakage is harder to deal with.
Wind load on a facade rises with height, exposure and building shape, and it decides the mullion size, bracket design and glass thickness. Calculations for the specific site are part of the design, so a system suited to a sheltered ground-floor screen may not suit an exposed upper storey.
Included as standard
- Final inspection, clean and maintenance guidance
- Supply and installation of framing, glass and panels
- System selection and glass specification for the building
- Fabrication drawings and coordination with other trades
About Ossett for this job
- Postcodes covered
- WF5, WF12, WF13 and the surrounding area, including Dewsbury, Batley and Wakefield
- Coast
- Ossett is well inland, around 58 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Ossett the midwinter sun reaches about 13° above the horizon at noon, with roughly 7.2 hours of daylight, rising to about 60° and 16.8 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Ossett
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
Choosing your curtain walling
Capped system
Glass clamped by pressure plates behind a visible external cap, available in different profiles and colours to emphasise the grid.
Integrated opening vents
Top-hung or parallel-opening vents built into the curtain wall grid to provide natural ventilation without breaking the facade line.
Opaque spandrel panels
Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.
Curtain Walling in Ossett: questions
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
Should I choose a stick or unitised curtain wall?
A stick system is assembled on site and generally suits low-rise buildings, entrances and smaller screens, with simpler logistics. A unitised system uses factory-made panels lifted into place, which reduces site joints and work at height but needs cranage and longer planning. The building's height, access and programme usually decide which is the right fit.
What affects the cost of curtain walling?
The main cost drivers are facade area, system type, glass specification, infill panels, opening vents, building height and access equipment such as scaffolding, hoists or cranes. Structural silicone glazing, unitised panels, fire-resisting sections and testing requirements add cost. See the guide prices for typical ranges, and your written quote fixes the price for the specification.
Do you cover Ossett for curtain walling?
Yes. We can quote for curtain walling across Ossett and the surrounding West Yorkshire area, including postcode districts WF5, WF12 and WF13, and nearby Dewsbury, Batley and Wakefield. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Ossett
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.