Wakefield · West Yorkshire
Curtain Walling in Wakefield
Planning a glazed facade in Wakefield? Our glaziers can survey the building and quote for stick or unitised curtain walling specified for its height, exposure and energy needs.
- WF1
- WF2
- WF4
- Guide from £455 per m²
Wakefield: glazed facade systems
Curtain walling needs planned upkeep. Clean frames and glass regularly, keep drainage outlets clear, and inspect gaskets, seals and fixings for shrinkage, gaps or corrosion. Failed or misted sealed units can usually be replaced individually without removing the surrounding framing.
Building regulations require external walls to limit the spread of fire, so curtain walling design has to consider how its materials react to fire and how fire could pass between floors. The requirements depend on the building's height and use, and differ between the UK nations.
Under the energy rules for new work in England, curtain walling performance is assessed for the whole system, including frames and opaque infill panels, not just the glass. Solar gain through the glass is also considered, so the glass choice balances heat loss, overheating and daylight.
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
What a typical job includes
- System selection and glass specification for the building
- Final inspection, clean and maintenance guidance
- Supply and installation of framing, glass and panels
- Survey of openings, supporting structure and access
About Wakefield for this job
- Postcodes covered
- WF1, WF2, WF4 and the surrounding area, including Ossett, Dewsbury and Morley
- Coast
- Wakefield is well inland, around 52 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Wakefield the midwinter sun reaches about 13° above the horizon at noon, with roughly 7.2 hours of daylight, rising to about 60° and 16.8 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- City-centre facades often need crane or hoist bookings, pavement or road licences, out-of-hours deliveries and close coordination with other trades. Tight sites need careful sequencing, and unitised panels can reduce the amount of work at height.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Wakefield
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Replacing windows and doors with similar ones is usually permitted development for houses in England. Flats, listed buildings and homes in conservation areas or covered by an Article 4 direction can need permission, so check with the council first.
What you can choose
Structural silicone glazing
Glass bonded to carrier frames with structural sealant, giving a flush external face with minimal visible framing.
Opaque spandrel panels
Insulated or back-painted glass panels that hide floor slabs, ceiling voids and services while keeping the facade's appearance consistent.
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Curtain Walling in Wakefield: questions
Can a single broken glass unit in a curtain wall be replaced?
Usually, yes. In capped systems the cap and pressure plate are removed to release the glass, and a new unit is fitted and resealed. Structurally bonded glass needs the new unit bonding to its carrier, which takes more preparation. Height and access drive much of the work, so we survey the unit and access before quoting.
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
How long does a curtain walling project take?
Timescales depend on size and complexity. Design, approvals and fabrication of framing and glass usually take several weeks to a few months before installation starts. Installation then depends on the facade area, access and sequencing with other trades. Replacing individual units is much quicker once the glass is made. Your written quote sets out the expected programme.
How does curtain walling keep water out?
Curtain walling uses outer gaskets and seals to shed most rain, with drainage routes inside the framing that collect any water getting past them and lead it back outside. Inner seals then provide the air seal. Keeping drainage outlets clear and gaskets in good condition is essential, because blocked drains or shrunk seals can let water into the building.
Do you cover Wakefield for curtain walling?
Yes. We can quote for curtain walling across Wakefield and the surrounding West Yorkshire area, including postcode districts WF1, WF2 and WF4, and nearby Ossett, Dewsbury and Morley. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Wakefield
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.