Putney · Greater London
Glass Balustrades in Putney
We cover Putney and Greater London for glass balustrades, from frameless balcony guarding to glass stair panels, with every job surveyed and quoted in writing before any glass is ordered.
- SW15
- SW6
- SW18
- Guide from £1,095
Putney: glass balustrade for decking
In England, Approved Document K sets minimum guarding heights. In a single-family home, stairs, landings and internal floor edges need at least 900mm, while external balconies, Juliet balconies and roof edges need at least 1100mm. Wales, Scotland and Northern Ireland publish their own guidance, so we check the figure that applies.
Where a building may be used by children under five, the guidance in England says guarding should not let a 100mm sphere pass through any opening and should not be easy to climb. Solid glass helps on both counts, but gaps between panels, posts, walls and the floor still need checking.
Under the guidance used in England, guarding is generally expected where there is a drop of more than 600mm in or around a dwelling, or more than 380mm in other buildings. Below those drops a glass screen is a design choice rather than a requirement, though the glass still has to suit its position.
Toughened glass cannot be cut, drilled or shaped once it has been toughened, so every hole, notch and corner is made before processing. That is why we template on site and order each panel to exact sizes. A panel made to the wrong measurement has to be remade, not trimmed.
Included as standard
- Final clean, film removal and care advice
- Fitting, levelling and alignment of every panel
- Templating and measuring for made-to-measure glass panels
- Channels, clamps, posts or spigots in your chosen finish
Local details for Putney
- Postcodes covered
- SW15, SW6, SW18 and the surrounding area, including Wandsworth, Barnes and Fulham
- Coast
- Putney is well inland, around 40 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Putney the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Glass guarding on a sunny balcony brings in heat and glare as well as the view. Tinted or satin glass can soften low winter sun on a terrace, while low-iron glass keeps colours true on north-facing spaces where every bit of daylight counts.
- Access and setting
- Flats and town houses often mean carrying long panels through stairwells or lifting them by hand to upper balconies, so panels may need splitting. Parking and loading limits, building management rules and leaseholder consents can all affect when we fit.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Putney
| Typical job | Guide price inc VAT |
|---|---|
| Frameless, 3 m run | £1,095 – £1,395 |
| Frameless, 6 m run | £2,195 – £2,795 |
| Post and clamp, 6 m run | £1,395 – £1,695 |
Get a guide price for your size
Approved Document K sets minimum guarding heights in England, typically 900 mm for internal stairs and landings and 1100 mm for balconies and external edges of homes. Glass guarding must be designed to resist the loads set out in BS 6180 and the loading standards it refers to.
Choosing your glass balustrades
Spigot fixed
Individual spigots hold each panel at its base instead of a continuous channel. Common on decking, around pools and in gardens.
Frameless channel system
Laminated toughened glass held in a continuous floor channel, giving a clean edge with no posts. Suits balconies, terraces, decks and modern stairs.
Side-fixed standoffs
Glass fixed to the face of a slab, stair stringer or balcony edge with round standoffs through drilled holes, keeping the walking surface completely clear.
Glass Balustrades in Putney: questions
Can I fit a glass balustrade kit myself?
Kits are sold for self-fitting, but a balustrade's safety depends on the right anchors, a sound substrate, the correct glass for the system and accurate alignment. Fixing into weak timber or using toughened-only glass in a frameless channel can leave a barrier that fails under load. We supply and fit as one job and check each fixing before handover.
How thick does the glass in a balustrade need to be?
Glass thickness depends on the fixing system, the panel height and the load the barrier must resist, so there is no single answer. Frameless channel systems commonly use thick laminated toughened glass, such as 21.5mm, while post and clamp systems often use thinner glass. The system maker's tested data sets the minimum, and we specify from that.
Can a glass balustrade be fitted to timber decking?
Yes, but the deck frame usually needs strengthening first. Glass guarding puts significant load into its fixings, and ordinary deck joists are not designed to take it. We check the frame at survey and may recommend steel brackets, extra blocking, or a post or spigot system instead of a long continuous channel.
Does a new glass balustrade need building control approval?
New guarding that forms part of wider building work, such as a new balcony, loft conversion or staircase, is normally checked by building control as part of that project. Whether a standalone replacement needs its own application depends on the work and on the nation, because England, Wales, Scotland and Northern Ireland have separate systems. We can advise at survey.
Do you cover Putney for glass balustrades?
Yes. We can quote for glass balustrades across Putney and the surrounding Greater London area, including postcode districts SW15, SW6 and SW18, and nearby Wandsworth, Barnes and Fulham. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Putney
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.