Mold · Clwyd
Glass Roofs in Mold
Looking for a glass roof in Mold? We can quote for structural glass roofs, fixed frameless rooflights and walk-on glass panels made to your design.
- CH7
- Guide from £1,095 per m²
Glass roof extension in Mold: what to know
Walk-on glass panels are laminated from several layers of toughened or heat-strengthened glass so the panel stays in place even if one layer breaks. The top layer usually carries an anti-slip finish, such as a fritted or etched pattern, and the panel thickness is calculated for the expected loads.
Glass roofs need regular cleaning from safe access, never by standing on non-walk-on glass. Silicone joints between panes should be inspected for splits, gutters and outlets kept clear, and any chips or scratches on walk-on panels checked, because the top layer is designed to protect the layers below.
Fixed frameless rooflights sit on a flat roof upstand with the glass edge overhanging the kerb, so from inside you see only sky and plaster. The upstand must be level, insulated and weathered into the roof covering, and the roof needs a fall so water drains off the glass.
A new glass roof or walk-on panel is building work that normally needs building regulations approval through building control, covering structure, energy performance and, close to a boundary, fire performance. Planning permission may also be needed depending on the extension and the property, so check with the council.
What you get
- Glass specification with laminated make-up and coatings
- Site survey and structural assessment of supports
- Weather sealing of joints, edges and upstands
- Lifting, positioning and fixing of every glass unit
Working in Mold
- Postcodes covered
- CH7 and the surrounding area, including Buckley, Deeside and Hawarden
- Coast
- Mold sits roughly 10 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Glass roofs near the coast collect salt film that self-cleaning coatings may not fully remove, so occasional rinsing helps. Exposed sites face higher wind uplift, which affects glass thickness and fixings, and any metal supports need coatings or grades suited to salt air.
- Daylight and sun
- In Mold the midwinter sun reaches about 13° above the horizon at noon, with roughly 7.3 hours of daylight, rising to about 60° and 16.7 hours in midsummer. Overhead glass admits far more daylight than vertical glazing, especially in summer when the sun is high. South-facing glass roofs usually need solar-control coatings or fritting, while north-facing roofs can use clearer low-E glass to maximise winter light.
- Access and setting
- Rural sites may have long or narrow access tracks that limit crane positions and panel sizes, so access is surveyed early. Exposed locations face higher wind and snow loads, and leaves and debris from nearby trees mean gutters need regular clearing.
- Rules in Wales
- In Wales, Approved Document N covers safety glazing: safety glass is needed in and around doors and in low-level glazing where people could walk into it.
Guide prices in Mold
| Typical job | Guide price inc VAT |
|---|---|
| Frameless glass roof, per m² | £1,095 – £1,795 |
| Walk-on glass panel, per m² | £1,495 – £2,395 |
Get a guide price for your size
Listed buildings in Wales need listed building consent for most changes to historic windows; Cadw publishes guidance on looking after traditional windows.
What you can choose
Sliding access rooflight
A glazed hatch that slides or hinges open for access to a roof terrace, with weather seals and secure locking.
Walk-on rooflight
A multi-layer laminated glass panel set into a roof terrace or flat roof, with an anti-slip surface for foot traffic.
Glass beams and fins
Laminated glass supporting beams instead of steel, keeping the whole roof transparent where spans and loads allow.
Glass Roofs in Mold: questions
How do you stop a glass roof leaking?
A glass roof stays watertight through a fall that lets water run off, weather seals and structural silicone joints between panes, well-detailed flashings at walls and upstands, and clear gutters or outlets. Most leaks start at flashings or blocked drainage rather than the glass. Annual checks of joints and outlets prevent most problems.
What is the difference between a glass roof and a roof lantern?
A glass roof replaces most or all of a roof with large structural glass units on minimal supports, giving a near frameless view of the sky. A roof lantern is a framed, pitched glazed structure that sits on an upstand within a solid flat roof. Glass roofs suit side returns and link extensions; lanterns suit openings in flat roofs.
Will a glass roof make my kitchen too hot?
A glass roof can make a room warm on sunny days, because overhead glass receives sun for much of the day. Solar-control coatings, fritted patterns, internal blinds and ventilation from opening windows or rooflights help keep temperatures comfortable. The glass is specified at design stage to suit the orientation and how the room is used.
Is a glass roof safe if the glass breaks?
A properly specified glass roof is designed so that a broken pane stays in place. The inner pane is laminated, so fragments remain bonded to the interlayer instead of falling into the room. The glass thickness, supports and edge details are designed for the expected loads, including snow, wind and maintenance access.
Do you cover Mold for glass roofs?
Yes. We can quote for glass roofs across Mold and the surrounding Clwyd area, including postcode districts CH7, and nearby Buckley, Deeside and Hawarden. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Mold
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.