Eccles · Greater Manchester
Glass Splashbacks in Eccles
We cover Eccles and Greater Manchester for glass splashbacks in kitchens, utility rooms and bathrooms, with every job templated on site and quoted in writing before the glass is made.
- M30
- M17
- M6
- Guide from £225
Toughened glass splashback for homes and businesses in Eccles
Hob makers set minimum clearances between the hob and nearby wall surfaces, and gas hobs in particular can have specific requirements. We check your hob's installation instructions before ordering so the glass, its cut-outs and any joints sit where the manufacturer allows.
Glass splashbacks have no grout lines to stain, so cleaning is simply a soft cloth with warm soapy water or a non-abrasive glass cleaner. Avoid scourers, abrasive creams and sharp scrapers, which can scratch the glass surface and dull the finish over time.
Our glaziers remove and refit socket and switch faceplates so the glass can sit behind them, with the power isolated first. Moving or adding sockets, or any other electrical alteration, needs a qualified electrician, ideally before the splashback is templated.
Colours look different on screens, in daylight and under kitchen lighting, so choose from a physical glass sample rather than a website or paint chart. We can match many paint and RAL colours, and a sample panel viewed in your own kitchen avoids surprises.
What's included
- Back-painting to your chosen colour or finish
- Toughened glass made to template with factory cut-outs
- Bonding with adhesive compatible with the painted back
- Silicone-finished edges, final clean and care advice
Eccles at a glance
- Postcodes covered
- M30, M17, M6 and the surrounding area, including Swinton, Salford and Stretford
- Coast
- Eccles is well inland, around 32 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Eccles the midwinter sun reaches about 13° above the horizon at noon, with roughly 7.2 hours of daylight, rising to about 60° and 16.8 hours in midsummer. Glossy glass reflects light from windows and under-cabinet lighting, brightening a dark kitchen. Low winter sun hitting a glass wall can cause glare, so a satin finish may suit a splashback that faces a south-facing window.
- Access and setting
- Older rural homes often have uneven solid walls with lime plaster or stone, so the wall may need making flat before glass can be bonded. Where a range cooker is fitted, its heat and clearance needs are checked before ordering.
- Rules in England
- Building regulations do not usually apply to this type of work, but we confirm anything that does in writing with your quote.
Guide prices in Eccles
| Typical job | Guide price inc VAT |
|---|---|
| Hob splashback, 900 × 750 mm | £225 – £285 |
| Run behind worktop, 2400 × 600 mm | £395 – £515 |
| Low-iron, 900 × 750 mm | £235 – £295 |
What you can choose
Back-painted colour
Toughened glass painted on the back in a matched colour, giving a smooth, glossy finish in almost any shade to suit units or walls.
Satin finish
Acid-etched glass with a soft, low-sheen face that reduces reflections and glare, useful opposite windows or bright lighting.
Printed design
A digitally printed image or pattern on the back of the glass, sealed behind it so the front stays smooth and wipeable.
Glass Splashbacks in Eccles: questions
Can a glass splashback go behind a hob?
Yes, provided it is toughened glass and the hob maker's clearances are followed. Toughened glass copes with the heat from a hob far better than ordinary glass, and it is what we fit behind cookers. Some gas hobs need a minimum gap to the wall, so we check your hob's instructions before the glass is ordered.
How long does it take to get a glass splashback fitted?
After templating, made-to-measure splashbacks are usually ready within a few weeks, depending on the colour and finish. Fitting a typical kitchen takes part of a day, and you can normally use the kitchen again once we have finished. The silicone needs time to cure fully, and we tell you how long on the day.
Can a glass splashback be fitted over existing tiles?
It is usually better to remove the tiles and make the wall good first. Glass needs a flat, sound surface for the adhesive to bond evenly, and grout lines, uneven tiles or loose tiles can show through or create stress points. Removing tiles also stops the glass standing too far forward of the worktop and sockets.
Why does my white glass splashback look slightly green?
Standard glass contains iron, which gives it a green tint that shows through pale back-painted colours, particularly white and cream. Low-iron glass has much less iron, so the colour behind looks close to the painted sample. If you are choosing a light colour, it is worth specifying low-iron glass from the start.
Do you cover Eccles for glass splashbacks?
Yes. We can quote for glass splashbacks across Eccles and the surrounding Greater Manchester area, including postcode districts M30, M17 and M6, and nearby Swinton, Salford and Stretford. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Eccles
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.