Powys · Wales
Glass Splashbacks in Powys
Looking for a glass splashback in Powys? Our glaziers can template your finished kitchen and quote for toughened, back-painted glass made with every socket cut-out in place.
- Guide from £225
- 4 towns covered
- Postcode areas LD, NP, SA, SY
Kitchen glass splashback in Powys: what to know
Hob makers set minimum clearances between the hob and nearby wall surfaces, and gas hobs in particular can have specific requirements. We check your hob's installation instructions before ordering so the glass, its cut-outs and any joints sit where the manufacturer allows.
Our glaziers remove and refit socket and switch faceplates so the glass can sit behind them, with the power isolated first. Moving or adding sockets, or any other electrical alteration, needs a qualified electrician, ideally before the splashback is templated.
Long runs and tall walls are usually made from more than one panel, because large sheets are heavy and hard to carry through houses. Joints are planned at corners, behind the hob centre line or at natural breaks, and are finished with a thin, neat silicone line.
Glass splashbacks have no grout lines to stain, so cleaning is simply a soft cloth with warm soapy water or a non-abrasive glass cleaner. Avoid scourers, abrasive creams and sharp scrapers, which can scratch the glass surface and dull the finish over time.
Towns we cover for glass splashbacks in Powys
Choose your town for local details, nearby areas and the postcode districts we cover.
What applies in Powys
Building regulations do not usually apply to this type of work, but we confirm anything that does in writing with your quote.
Powys is inland, around 45 km from the nearest coast at its closest point, so salt exposure is rarely a factor.
Older rural homes often have uneven solid walls with lime plaster or stone, so the wall may need making flat before glass can be bonded. Where a range cooker is fitted, its heat and clearance needs are checked before ordering.
Guide prices
| Typical job | Guide price inc VAT |
|---|---|
| Hob splashback, 900 × 750 mm | £225 – £285 |
| Run behind worktop, 2400 × 600 mm | £395 – £515 |
| Low-iron, 900 × 750 mm | £235 – £295 |
Choosing your glass splashbacks
Printed design
A digitally printed image or pattern on the back of the glass, sealed behind it so the front stays smooth and wipeable.
Low-iron glass
Glass with less iron, removing the green tint of standard glass so whites, creams and pale colours look true to the sample.
Back-painted colour
Toughened glass painted on the back in a matched colour, giving a smooth, glossy finish in almost any shade to suit units or walls.
Clear glass panel
Unpainted toughened glass over a painted wall or feature finish, protecting it from splashes while letting the surface behind show.
Glass Splashbacks in Powys: questions
How long does it take to get a glass splashback fitted?
After templating, made-to-measure splashbacks are usually ready within a few weeks, depending on the colour and finish. Fitting a typical kitchen takes part of a day, and you can normally use the kitchen again once we have finished. The silicone needs time to cure fully, and we tell you how long on the day.
Can a glass splashback be fitted over existing tiles?
It is usually better to remove the tiles and make the wall good first. Glass needs a flat, sound surface for the adhesive to bond evenly, and grout lines, uneven tiles or loose tiles can show through or create stress points. Removing tiles also stops the glass standing too far forward of the worktop and sockets.
Can a glass splashback go behind a hob?
Yes, provided it is toughened glass and the hob maker's clearances are followed. Toughened glass copes with the heat from a hob far better than ordinary glass, and it is what we fit behind cookers. Some gas hobs need a minimum gap to the wall, so we check your hob's instructions before the glass is ordered.
Why does my white glass splashback look slightly green?
Standard glass contains iron, which gives it a green tint that shows through pale back-painted colours, particularly white and cream. Low-iron glass has much less iron, so the colour behind looks close to the painted sample. If you are choosing a light colour, it is worth specifying low-iron glass from the start.
Which parts of Powys do you cover for glass splashbacks?
We cover the whole of Powys, including Newtown, Brecon, Welshpool and Llandrindod Wells, and postcode areas LD, NP, SA, SY. Building rules for glass splashbacks here follow the regulations for Wales. Enter your postcode on the quote form and we will confirm cover; then a glazier will arrange a free survey before giving you a written quote.
Other glazing services in Powys
- Replacement Glass in Powys
- Misted Glass Repair in Powys
- Emergency Glazing in Powys
- Safety Glass in Powys
- Window Repairs in Powys
- Window Film in Powys
- uPVC Windows in Powys
- Aluminium Windows in Powys
- Sash Windows in Powys
- Composite Doors in Powys
- Bifold Doors in Powys
- Sliding Doors in Powys
- Secondary Glazing in Powys
- Roof Lanterns in Powys
- Glass Balustrades in Powys
- Frameless Glass in Powys
- Shower Screens in Powys
- Bespoke Mirrors in Powys
- Glass Roofs in Powys
- Shopfront Glazing in Powys
- Curtain Walling in Powys
- Glass Partitions in Powys
- Property Glazing in Powys
Get a written quote in Powys
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.