Irvine · Ayrshire
Misted Glass Repair in Irvine
Cloudy, streaky double glazing in Irvine is usually a failed sealed unit, and we can quote to replace it without disturbing the frame.
- KA11
- KA12
- Guide from £155
Misted double glazing in Irvine: what to know
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
A new unit has to match the overall thickness of the old one so it sits in the existing rebate and takes the original beads. The glazier also notes any Georgian bars, leaded designs or obscure patterns so the replacement matches the other windows in the room.
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Early seal failure often shows only on cold mornings or after rain and clears during the day. As the desiccant fills, the mist lasts longer and white mineral staining can form on the inner faces. Staining inside the unit cannot be removed by cleaning from either side.
What you get
- Written quote fixing the price for the specification
- Fitting on packers with drainage slots checked
- Survey to confirm the mist is inside the unit
- Made-to-measure replacement units matching your windows
Irvine at a glance
- Postcodes covered
- KA11, KA12 and the surrounding area, including Kilwinning, Saltcoats and Troon
- Coast
- Irvine is about 3 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Irvine the midwinter sun reaches about 11° above the horizon at noon, with roughly 6.8 hours of daylight, rising to about 58° and 17.2 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in Scotland
- Section 4 (Safety) of the Scottish Technical Handbooks covers glazing that people could collide with, such as glass in and beside doors and low-level glazing, where safety glass is needed.
Guide prices in Irvine
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Section 6 (Energy) of the Scottish Technical Handbooks sets the thermal performance that replacement windows, doors and rooflights should achieve.
Choosing your misted glass repair
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Obscure glass unit
Patterned glass for bathrooms, landings and front doors, chosen to match existing obscure panes or to add privacy.
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Misted Glass Repair in Irvine: questions
Can you clean the inside of a misted double glazing unit?
Not without breaking the seal. Some firms drill the glass, flush the cavity and fit a small vent, which can clear the mist for a while. It does not restore an airtight seal or gas fill, and white staining may not fully clear. Replacing the unit is the reliable way to restore a clear, sealed cavity.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
How much does it cost to replace a misted sealed unit?
The cost depends on the size of the unit, the glass type, any Georgian bars, leaded or obscure features, how many units are done together, and access to the window. Larger units, safety glass and upper-floor windows cost more. See the guide prices for typical sizes, then get a written quote for your exact windows.
Are misted units covered by a guarantee?
Often they are, for a period after installation. Many sealed unit manufacturers guarantee against misting, and the terms are set out in the paperwork from the original installer. If your units are still covered, contact that installer first. Units we supply carry manufacturer guarantees, and the terms are confirmed in writing with your quote.
Do you cover Irvine for misted glass repair?
Yes. We can quote for misted glass repair across Irvine and the surrounding Ayrshire area, including postcode districts KA11 and KA12, and nearby Kilwinning, Saltcoats and Troon. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Irvine
Misted Glass Repair nearby
Get a written quote in Irvine
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.