Dorchester · Dorset
Misted Glass Repair in Dorchester
Is there fog between the panes of your windows in Dorchester? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- DT1
- Guide from £155
Misted double glazing across Dorchester
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
Once the seal has failed, any argon or other insulating gas in the cavity has escaped and been replaced by ordinary damp air. The unit insulates less well than when it was new, and moisture inside can gradually leave deposits that dull the glass.
A new unit has to match the overall thickness of the old one so it sits in the existing rebate and takes the original beads. The glazier also notes any Georgian bars, leaded designs or obscure patterns so the replacement matches the other windows in the room.
Common causes of seal failure include water sitting in the frame rebate because drainage holes are blocked, units fitted without correct packers, strong sun on dark frames, and age. Clearing the drainage slots in the frame helps protect the new unit from the same problem.
What a typical job includes
- Made-to-measure replacement units matching your windows
- Written quote fixing the price for the specification
- Survey to confirm the mist is inside the unit
- Measurement of each failed sealed unit
About Dorchester for this job
- Postcodes covered
- DT1 and the surrounding area, including Weymouth, Bridport and Yeovil
- Coast
- Dorchester sits roughly 8 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Dorchester the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 63° and 16.3 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Dorchester
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Choosing your misted glass repair
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Misted Glass Repair in Dorchester: questions
Are misted units covered by a guarantee?
Often they are, for a period after installation. Many sealed unit manufacturers guarantee against misting, and the terms are set out in the paperwork from the original installer. If your units are still covered, contact that installer first. Units we supply carry manufacturer guarantees, and the terms are confirmed in writing with your quote.
Can misted double glazing be fixed without replacing the window?
Yes. In most cases only the sealed unit needs replacing, not the frame. The glazier removes the beads, lifts out the misted unit and fits a new one made to the same thickness. Your frames, hinges, handles and locks stay as they are, provided they are in good condition, which the glazier checks at the survey.
How can I stop new sealed units misting early?
Keep the drainage slots at the bottom of the frame clear, so rainwater does not sit around the unit edges. Avoid pressure washing the seals, and do not paint over glazing gaskets. Check that opening sashes close properly, as a dropped sash can stress the unit. Report any cracked beads or failed gaskets early.
Will a new unit match my other windows?
It can. The glazier records the unit thickness, spacer bar colour, any Georgian bars or leaded designs, and the obscure glass pattern if there is one. Most details can be matched closely. If an obscure pattern has been discontinued, the quote offers the closest available alternative so you can decide before anything is ordered.
Do you cover Dorchester for misted glass repair?
Yes. We can quote for misted glass repair across Dorchester and the surrounding Dorset area, including postcode districts DT1, and nearby Weymouth, Bridport and Yeovil. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Dorchester
Misted Glass Repair nearby
Get a written quote in Dorchester
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.